Wolo RC-100 Installation Instructions

INSTALLATION INSTRUCTIONS FOR MODEL RC-100 • WIRELESS WIZARD
Your choice of Wolo's remote control switch system is the perfect choice to compliment your vehicle or vessel.
Wolo's products are manufactured with the finest quality materials and every remote system is inspected
and tested before being packaged. The Wireless Wizard is built with state-of-the-art electronics, assuring
years of reliable service. If you need help installing your new Wolo remote system, or have any questions,
our technicians are available to answer your questions, Monday through Friday from 9 AM to 4 PM EST
at 1-888-550-HORN (4676)
There are Two operaTing modes To choose from:
1. horn momenTarY mode: When the remote's push button is pressed, it will illuminate blue, to advise
that a coded signal is being wirelessly transmitted to the receiver. The receiver will then turn on and power
the horn until the remote's push button is released. Press the remote's button switch, the horn will sound;
release button switch and the horn will turn off.
2. accessorY on / off mode: When the remote's push button is pressed, it will illuminate blue, to advise
that a coded signal is being wirelessly transmitted to the receiver. The receiver will then turn on and power
the accessory. The accessory will remain powered until the remote's push button is pressed and released
a second time. Press and release the remote's button switch, turn on the accessory. Press and release the
remote's button switch a second time and the accessory will turn off.
Before installation of the Wireless Wizard is attempted, it is important to read these instructions completely and
note any messages marked "imporTanT".
moUnTing remoTe TransmiTer: fig. 1
3. Open the battery compartment by pushing downward on the cover. Insert
the battery provided. imporTanT: Position the battery as illustrated by
the diagram inside the battery compartment.
4. Press the remote's button switch and it will illuminate blue. If the button
does not illuminate, remove the battery and reverse the direction.
5. Slide the battery cover back into position. The remote control transmitter
is now ready to be mounted. Locate a flat surface that can easily be
reached. imporTanT: always carefully inspect mounting location to
ensure that it will not interfere with the air bags, vehicle's operation,
or impair the driver's vision. Consult the vehicle's shop manual or
dealer if the installer is not familiar with the deployment area of the air
bags.
6. imporTanT: Never mount the remote transmitter on the steering wheel.
Doing such could cause injury or death if the air bag is deployed.
7. Using the Velcro tape provided, mount the remote control transmitter to the desired location. Make sure
®
that mounting surface is free from dust, wax, oil and etc. A clean mounting surface is necessary for the tape
to adhere properly.
imporTanT: THE TAPE'S ADHESIVE HOLDING POWER BECOMES MAXIMUM IN 24 HOURS. LIMIT
MOVING OR PUTTING PRESSURE ONTO THE REMOTE TRANSMITTER UNTIL THEN.
fig. 1
Battery
Compartment
Peel off
Peel off
TM