Table of Contents
Advertisement
Battery Replacement
1. Remove the single screw on the battery door, located in the back of
the Snap Shot™ towards the bottom of the unit, with a #1 Philips
head screwdriver.
2. Take off the battery door and remove old batteries.
3. Replace with four AA Alkaline batteries. Slide batteries into the
battery cartridge according to the diagram imprinted on the bottom of
the battery compartment.
4. Return the battery door to the unit and tighten the screw to secure
the battery door.
Do not over tighten the battery door. Doing so can damage the
test unit.
Cleaning
Use a damp, clean cloth to clean the test unit.
Disconnect all cables from the Snap Shot™ prior to cleaning.
Failing to do so can damage the unit and result in personal injury.
Do not use abrasive, harsh cleaners, or solvents to clean the
Snap Shot™.
Storage
When the Snap Shot™ is not in use, store in a dry, protective case. The
batteries should be removed if the unit is stored for a long period of time.
Do not expose the Snap Shot™ to high temperatures or humidity. When
stored in temperatures exceeding the limits listed in the Specifications
section, allow the Snap Shot™ to return to the normal, recommended
operating conditions prior to use.
MAINTENANCE
26
Advertisement
Table of Contents
