Bowens PULSAR BWL-0340/1 Instructions Manual

Bowens PULSAR BWL-0340/1 Instructions Manual

Radio trigger

Advertisement

IMPORTANT
MODIFICATIONS TO THE
EQUIPMENT MAY VOID YOUR AUTHORITY TO USE THIS
PRODUCT UNDER THE EQUIPMENT AUTHORISATION
GRANTED BY THE REGULATING AGENCIES.
Bowens International Limited
Q89-5150
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received including interference that
may cause undesired operation.
PULSAR RADIO TRIGGER INSTRUCTIONS BWL-0340/1
BOWENS INTERNATIONAL LIMITED
355 Old Road
Clacton on Sea
Essex CO15 3RH UK
Tel:
+44 (0)1255 422807
Fax:
+44 (0)1255 436342
www.bowensinternational.com
OPERATION
OF THIS
BOWENS
User Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PULSAR BWL-0340/1 and is the answer not in the manual?

Questions and answers

Summary of Contents for Bowens PULSAR BWL-0340/1

  • Page 1 EQUIPMENT MAY VOID YOUR AUTHORITY TO USE THIS PRODUCT UNDER THE EQUIPMENT AUTHORISATION GRANTED BY THE REGULATING AGENCIES. Bowens International Limited Q89-5150 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received including interference that may cause undesired operation.
  • Page 2: Troubleshooting

    Turn Pulsar OFF then back ON. 1 x Sync Cord 1 x Jack Plug Adapter In the unlikely event of a problem or fault with your Pulsar please contact Bowens for additional help or to arrange a repair. www.bowensinternational.com www.bowensinternational.com...
  • Page 3: Specifications

    Pulsar External Power Supply. Motor drive Camera Sync-Cord. QUADX 5V to 3V Adapter. For details contact your distributor. Due to our policy of constant product improvement Bowens International Limited reserve the right to change equipment specification without notice. www.bowensinternational.com www.bowensinternational.com...
  • Page 4: Advanced Connection

    Channel codes and Switches Advanced Connection Triggering Remote Camera Channel Select All-4 Test Button Indicator Studio Select A-F Motor drive * * Optional ‘Motor Drive’ cable not included. This cable is camera specific. Please consult your camera Sync Out Triggered manual details PC Sync Out...
  • Page 5: Standard Connection

    Standard Connection Power Requirements Receiver Connection If the unit is left for long periods of time, the batteries should be removed. Receive Mode When the indicator 'double flashes' the batteries should be changed at To Flash Equipment the earliest opportunity. Jack Socket Adapter Battery Indicator Transmitter Connections...
  • Page 6 Metering Flash Settings Mounting Pulsar To measure the settings of multiple flash equipment using a light meter Positioning Pulsar follow this example. Make sure unit is Example:- Using 4 flash units each with a Pulsar set as receiver. firmly secured. The higher the Ch.1 transmitter usually...
  • Page 7: Mounting Bracket

    Mounting Bracket Studio Operation The Studio selector provides isolation for Studio separate lighting studios or users. Sticky Feet Positions The Channel Selector Channel provides a unique ID for All 1 2 3 4 Mounting Bracket each flash device. (Supplied) Place mounting bracket against suitable object.
  • Page 8: Using Channels

    Orientation Using Channels The Pulsar antenna should be kept clear of metal objects to ensure The Channel selector can be used to control Channel reliable operation. various lighting equipment by setting the channel All 1 2 3 4 switch on the Transmitter and receiver to the same channel.

Table of Contents