Summary of Contents for infa-secure CS40
- Page 1 CS40/41 Suitable from Convertible Carseat newborn to 18kgs CS40/41 ISSUE:2004/A IMPORTANT...
- Page 2 REFER TO A CHILD RESTRAINT FITTING STATION IF NO ANCHORAGE POINTS ARE IN THE MOTOR CAR. INFA-SECURE PTY LTD Australian Service Agent DESIGNED IN AUSTRALIA P.O. Box 487, Emu Plains NSW 2750 MADE IN CHINA Service No: 02 4728 8090 www.infa-secure.com.au SECURE NO: CS40/41...
- Page 3 IMPORTANT: Care must be taken that food, sticky liquids (eg fruit juice, milk formulas, etc) does not get inside www.infa-secure.com.au your harness buckle as it may become sluggish. If you do not hear an audible click when engaging the buckle it may mean it is becoming sluggish.
- Page 4 HOW TO INSTALL ANCHORAGE FITTINGS TO REMOVE COVER FOR VEHICLES FITTED WITH ANCHORAGE POINTS. Step 1: Do step 1 to 3 from “to change the shoulder slot height” on page 6. Step 2: Disengage the buckle and tongues. Push the buckle through the crotch slot in the cover. Pull the THIS RESTRAINT MUST BE ATTACHED TO A CHILD RESTRAINT ANCHORAGE POINT IN THE CAR.
- Page 5 ADJUSTING RECLINE ANGLE HOW TO INSTALL: INFANT POSITION (0-9 KG) To adjust the recline angle, undo red clamp, loosen lap sash Suitable for a child up to 9kg. section across base, adjust to require recline angle and tighten For dimensions of restraint when installed, see figure 3A below. vehicle belt as described in step 4.
- Page 6 Step 6: Make sure upper anchorage strap (B) is as in illustration (Figures 4 and 4A) i.e. positioned around restraint back. INSTALLATION INSTRUCTIONS FOR CHILD POSITION (8-18 KG) (F) Anchorage (F) Anchorage (B) Upper Anchorage Point (C) Adjuster Point Strap UPRIGHT OR RECLINED POSITION Figure 6 *NOTE: SOME ILLUSTRATIONS SHOWN WITH HEADREST...