Onnet Konnect Manual page 11

Notice:
1. Do not use the network USB server in the extreme hot, cold, dusty or humid
2. Prevent friction with objects or it may lead to surface abrasion or hardware damage.
3. Avoid the hub falling down from a high place, or it may damage the hardware inside.
4. Do not use any alcohol, thinner or benzene to clean the device.
5. Please do not use power adaptor with different voltage rating. It will damage or burn
6. Always check I the device driver is required by some USB peripherals such as
7. Some USB devices require a direct connection to PC for optimum performance.
8. The network hub provides 5V power supply which is enough for most USB devices
9. Make sure your network is working and the network cable is connected to the network
10. You may need to configure the IP address of the network before accessing any USB
IMPORTANT NOTE:
You can reset your network PRINT server to default setting by press the "RESET'
button on the back side of the hub. You can use this solution if you forget your
password.
11
environment.
the network print server.
printers etc. please install the device driver is require on your computer first.
but the power can be in short supply when connecting too many devices like 2.5'
external hard disk or .connecting other devices with high power consumption
simultaneously. Please attach their self-power supply in order to co-work with the
network hub properly.
hub as well.
LPR printer connected with the hub. Please read the user manual