Basic Operation; Batteries; Power On/Off, Volume; Listening To Fm - Eton G1000A How To Use Manual

B A S I C

1. BATTERIES

Remove the battery compartment cover by pushing it in
the direction of the arrow. Install two 'AA' batteries
according to the polarity symbols (+ and -) marked next to
the compartment. For easy removal, place the batteries on
top of the lift-out ribbon.

2. POWER ON/OFF, VOLUME

Turn the radio on by switching the power on/off switch
(11). Use the volume knob (21) to adjust the volume.

3. LISTENING TO FM

Select the FM band by using the band selector switch (13).
Use the tuning knob (6) to tune the radio to the desired
frequency. When a strong signal is found, the TUNE
indicator will light. If you are using an earphone to listen
to FM stereo, the FM ST. LED (5) will light. Note that the
frequency of the station appears in the display (3).

4. LISTEN TO AM or SW1-8

Select the desired band, AM or SW 1-8, by using the band
selector switch (13). Turn the tuning knob (6) to the
desired frequency which appears in the display (3) or just
tune around and listen for stations. Note that MW appears
in the display when AM is selected. That's because the AM
band is called MW (for medium wave) in some parts of the
world. SW appears in the display when SW 1-8 is selected.

5. ANTENNA

A. For AM (MW) the radio uses an internal, directional,
ferrite bar antenna. Rotate the radio for best reception.
B. For FM/SW, fully extend the telescopic antenna (1). For
FM, rotate it for best reception.
O P E R A T I O N
6