Do you have a question about the B-40 and is the answer not in the manual?
Questions and answers
Summary of Contents for Finn Corporation B-40
Page 1
Activate Activate Your Warranty Your Warranty By Registering By Registering 9281 LeSaint Drive • Fairfield, Ohio 45014 TODAY!!! TODAY!!! Phone (513) 874-2818 • Fax (513) 874-2914 Sales:1-800-543-7166 B-40 Straw Blower Parts and Operator’s Manual Model MD Serial No. _____________ LBB40-MO...
Page 3
Once your FINN equipment has been registered, your FINN Limited Warranty will be activated per the warranty statement on the next page. <<What should you do if you need repairs or parts under Warranty?>> NOTIFY FINN CORPORATION OF THE FAILURE OF MATERIAL OR WORKMANSHIP 1-800-543-7166 Extension (246) WARRANTY@FINNCORP.COM...
Page 4
4. The warranty shall be null and void to the extent any defect or failure of Finn Corporation warrants to you, the original purchaser, for use (or rental to the products warranted arises out of or is caused by accessories or...
SAFETY FIRST With any piece of equipment, new or used, the most important part of its operation is SAFETY! FINN Corporation encourages you and your employees to familiarize yourselves with your new equipment and stresses safe operation. The first five pages of this manual are a summary of the main safety aspects associated with this unit.
Its use with other products or for other applications must be by approval of the product’s manufacturer. If there are any questions, contact FINN Corporation at 1-800-543-7166. Make sure the discharge spray area is clear of all PRE-START EQUIPMENT CHECK (equipment persons, animals, etc.
Page 9
Make certain that all decals on the machine are tion. Shut down the engine maintained in good legible condition. Replacement using Occupational Safety decals are available through FINN Corporation by and Health Administration specifying the part number shown in the lower right- (OSHA) lockout/tagout pro- hand corner of the decal.
Page 10
CURRENT SET OF SAFETY DECALS W A R N I N G THROWN OBJECT HAZARD KEEP AWAY To prevent serious injury or death from Wear eye protection thrown objects: Do not operate around operating Stay away from discharge area during operation.
TOWING VEHICLE The truck used to tow the FINN B-40 Straw Blower should have a bed large enough to carry the quantity of mulch needed for economical operation. The truck must be equipped with a 2 in. ball rated 3000 lb (1360 kg).
ENGAGE position. The clutch is then activated using an electrical pulse and will gradually engage over a 3-second time span. NOTE: When starting your B-40 Straw Blower under cold conditions: until engine warms to the appropriate operating temperature, it may be necessary to slightly increase the choke before engaging the blower.
BLOWER DISCHARGE The B-40 Straw Blower should be towed to a point approximately 20 ft (6 m) from the area where the mulch is to be applied. The operator elevates the discharge spout about 10 degrees above the plane of the seedbed so that the mulch floats onto the seedbed.
AFTER FIRST 4 TO 8 HOURS OF OPERATION 1. Check and adjust belt. Proper tension is obtained when 3/8 in. (1 cm) of belt deflection is obtained at the center of the belt span with a force of 5 lb (2.2 kg) with a used belt and 7 lb (3.2 kg) with a new belt.
LUBRICATION AND FLUIDS CHART Ref. No. Location Lubricant Frequency Number Grease drive shaft bearings. Weekly Check fuel tank level. Daily Check engine oil level. Daily Check air cleaner. Daily Service pre-cleaner element. Every 25 Hours Change air cleaner element. Every 100 Hours Change engine oil and filter.
WHITE BROWN BLACK BROWN BLACK WHITE BLACK BLACK BREAK- AWAY GROUND BATTERY "+" WHITE BROWN TRAILER WIRING Part No. Description No. Required 035060 Trailer Wiring 060069 Plug and Recepticle 005137 Left-Hand Taillight 005137-A Taillight Lens 005138 Right-Hand Taillight 005137-A Taillight Lens WHEN ORDERING PARTS, BE SURE TO STATE SERIAL NUMBER OF MACHINE...
Need help?
Do you have a question about the B-40 and is the answer not in the manual?
Questions and answers