Commodore 1084S Manual page 13

C 128
BE SURE TO DISCONNECT THE POWER TO BOTH THE MONI-
TOR AND THE COMPUTER TO PREVENT DAMAGE BY
SHORTING.
With
a
Commodore PC or Commodore 128 -
Set the
CVBS/RGB button to RGB mode before making any connections.
Then, insert the 8-pin DIN connector into the port labeled
TTL RGB
• on the back of your 1084S and the 9-pin D connector into the video
port on your computer. (Be sure to tighten the screws on each side
of the connector.) Depending on which computer you have, the
video port may be labeled Video or RGBI- or it may not be
label~d
at all.
NOTE: The Digital RGBI and Analog RGB video signals CANNOT
BE USED AT THE SAME TIME. They can be connected at the
same time, but both devices cannot be powered on at the same--
time. If you do, you will either see a scrambled picture or no picture
at all.
7