Thank you for specifying the PATLITE Signal Tower for your application. Please read these instructions carefully before
you perform installation, maintenance and repair. Store this manual carefully for easy reference. If you have any
questions about this product, please contact PATLITE Corporation.
1. To operate this product safely, please observe the following
Notes to be followed to prevent any damage to the user and other personnel or to assets are as follows:
■The indications for warning are divided into the following classes according to the degree of danger or
damage incurred when the warning is not taken into consideration and the product is not correctly used.
Warning
Caution
Warning
● Make sure the power is OFF before wiring. Wrong wiring may result in a cause of short circuit or electric shock.
● Make sure the power is OFF to avoid an electric shock or burn when repair or replace the parts.
● Do not use this product with damaged lens or leave it without the lens or head cover. That may cause an electric shock.
● If installing this product requires a construction work, please ask to a specialistin order to avoid a risk of an electric shock,
fire or fall.
● When this product is used for security purposes, it should be inspected daily. In case a malfunction should occur,
it is recommended that you use this product together with other security products.
● Be careful not to hold the product to climb any machines attached the product to also be careful not to catch the cover of
machine on this product when you remove the cover, as it may cause of falling down or drop.
Caution
● Concerning replacement parts, such as LED unit, bulb or fuse, be sure to use those specified in this manual.
● For safety, make sure to connect an external fuse to the power source as shown in the wiring example.
● Do not substitute parts of units from other products. It may cause a breakdown.
2. Model No. configuration
〔Base unit〕
LU7-□□FB
■Rated voltage
02:24V DC
M2:90~250V AC
3. Parts name and Dimensions
■Parts name
< LED unit >
< Base unit >
Head cover
Screw for fitting Body
with Terminal block
Waterproof sheet
INSTALLATION MANUAL
NOTES TO BE OBSERVED FOR SAFE OPERATION
Indicates an imminently dangerous condition: failure to follow
the instructions may lead to death or serious injury.
Indicates a potentially dangerous condition: failure to follow
the instructions may lead to slight injury or property damage.
■Light method
FB:Continuous light or flashing,
with buzzer
Nothing:Continuous light
※Refer to "6. Unit reformation" to
assemble the each unit.
Body
Terminal block
Volume
VOL.
Mounting screw
Signal Tower
Type : LU7
■Dimension
<Bottom Side>
Wire Exit
The Cable Gland
can be installed.
-6-
〔LED unit〕
LU 7-E -□
■LED unit
φ70
VOL.
Panel board maximum
installable thickness : 10
■LED color
R:Red
A:Amber
G:Green
B:Blue
C:White
( Unit:mm )