Advertisement
Establishing a Connection between the Mouse and the Computer
1
Plug the Nano receiver into an available USB port on your computer.
2
Slide the Power switch upward to the ON position.
3
The battery indicator light on the top of the mouse will glow red for approximately three
seconds. When the light turns off, the mouse is ready for use.
NOTE
The mouse will enter sleep mode after a period of time to conserve power. Move the mouse or click the
button to wake it up.
Low Battery Warning
Replace batteries when the battery indicator light flashes red for five seconds.
Troubleshooting
Problem Solution(s)
Mouse does not work make sure you have installed the mouse correctly.
Make sure the Nano receiver is plugged into an available USB port on your computer. Make sure the
mouse has been detected properly by the operating system. Refer to your computer documentation for
the correct port configuration. Connection failed. Disconnect the Nano receiver from the USB port on
your computer, and then re-connect it. If the mouse does not work after ten seconds, press the Connect
button on the bottom of the mouse to pair the mouse and the computer.
1.
Do not use the wireless optical mouse on a desk which is made of clear glass or mirror.
2.
If you feel the mouse does not move smooth as usual, it is possible the batteries have lost their
charge so you need to replace them. Remember to put the batteries in the correct direction.
3.
The connection of the wireless device is factory preset, so when you plug the USB receiver into any
USB port, the connection between the micro receiver and the mouse will be established
automatically.
4.
In case your laptop or PC did not install the hardware successfully, remove the micro receiver from
the USB port and go Human Interface Devices under Device Manager to remove the mouse then
plug in the micro receiver to a USB port again.
Toshiba Wireless Optical Mouse W30
Advertisement
