Philips BDP7700 Service Manual page 19

Software check and upgrade
Preparation to upgrade software
1)Start the CD burning software & create a folder named "UPG_ALL",
2)Then copy the Bin file (BDP7700.bin ) into it,
3)Burn the data onto the blank CD or USB.
A. Procedure for software upgrade
A) Upgrade software via Disc
1) Power on the set and insert the prepared Upgrade CD.
2) The set will starts reading disc & response with the
following display TV screen:
Now searching for upgrade software!
Please wait!
3) Wait for a few seconds, then screen will display:
Software upgrade for this player have been found. Do you want to
(choosing "Cancle" or"Start" shows on TV set)
upgrade?
4) Press Right cursor button to choose "Start", then press <OK>;
5) The software will upgrade and screen will display as below:
Upgrade is ongoing, Please wait.
Please do not unplug or switch off the device.
6) The screen will display as below when upgrading complete:
Upgrade has completed successfully!
Power off after 5s.
Software BE:Passed
Software FE:Passed
5) Restart the set.
(choosing "Restart" shows on TV set)
B) Upgrade softwar via network:
1) Setup the network connection (See "Getting started">"Set up
network").
2) In the Home menu, select <Setting>-<Advanced Setup>-
<Software Download>-<Network>.
* You are prompted to start upgrading processes if upgrade
media is detected.
3) Follow the instructions on the TV screen to confirm update
operation.
* Once software updated is complete, this player automatically
truns to reboot.
C) Update software via USB Flash Drive:
1) Go to www.philips.com/support to check if the latest software
version is available for this player.
2) Download the software onto a USB flash drive.
3) Insert the USB flash drive to the USB jack of the rear panel.
4) In the Home menu, select <Setup>-<Advanced Setup>-<Software Updade
>-<USB>.
5) Follow the instructions on the TV screen to confrim update operation.
* Once software update is complete, this player automatically turns to
reboot.
3-1
B. Read out the software versions to confirm upgrading
1) Power on the set.
2) Press <Home> button on the reomote control.
3) Select <Setup>, then press <OK>.
4) Select <Advanced Setup>, press right cursor to choose
<Version Info.>, then press <OK>, the software version
and other information will display on the TV screen as below:
Model:BDP7700
Versions:
System SW: XXX
Ethernet MAC:XX-XX-XX-XX-XX-XX
Wireless MAC:XX-XX-XX-XX-XX-XX
For Information,frequently asked questions and software updates,visit
www.philips.com/support
Caution: The set must not be power off during
upgrading, otherwise the Main board will be
damaged entirely.