Advertisement
Page 3 • JL Audio, Inc., 2016
S T E P 1
Empty out the cargo area of the vehicle and fold the rear
seats down.
S T E P 2
Lift and remove the floor cover panel. Remove the jack tools
from the plastic tray, then carefully unclip and remove the
tray.
S T E P 3
On the rear driver's side of the plastic tray, measure and mark
2" from the bottom.
S T E P 4
Measure and mark 1" to the right of the first rib. Using a 1/8"
drill bit, drill a pilot hole on the intersection of the two marks.
SB-H-PLT/10TW3 INSTR_SKU# 011365
S T E P 5
Measure and mark 2" up from the bottom and 1-1/4" to the
right of the second large rib. Using a 1/8" drill bit, drill a pilot
hole on the intersection of the two marks.
S T E P 6
Pictured are the locations of the two pilot holes.
S T E P 7
On the front driver's side of the plastic tray, measure and
mark 3-5/8" from the bottom.
S T E P 8
Measure and mark 1-7/8" to the right of the rib. Using a 1/8"
drill bit, drill a pilot hole on the intersection of the two marks.
Continued on Next Page
Advertisement
