Drying Device - JINGOA JDZ-1030 Operation Manual

JD Screen Label Printing Machine Series
time, the machine just will be run one cycle only and not continue
)
Make sure Printing total：0 /1/2/3....(If the count number is 6000 more than Stop time:
2000 /3000/5000, press screen number of the printing total in a few seconds ,it will be
change as 0)
Doctor Blade Length :( during printing area)
Doctor Blade Times: can be 1 or according to you requirement)
Manual
Unwind On
Set T/Min
Left-move
Right-move
Clear blowing
ON
OFF
Front rotation for gluing (when put glue in the conveyor belt, will use that)
Back rotation for gluing
Blade down
Blade up
Start
Conveyor belt moving
Manual speed of feeding (set well before out of factory)
Automatic speed of feeding: (during 500-5500)
Manual speed of doctor blade (set well before out of factory)
Automatic speed of doctor blade:(during 500-5500)
Length of mark: press this key to move the mark
Back
No mark: use this key for twice printing
: for twice printing, the labor material of color is white or light color,
Sensor indicating Light
mark working of color is used for labor with black or dark black.
Page down
Rotation
Doctor Blade Delay
Vacuum Intake Delay
Stop Intake Delay
Puller Mark Delay
Vacuum Blowing Time
(Set well before out of factory)

2.3 Drying device

It is equipped with ironing plate drying oven, its temperature is not more than 100℃.
(This machine has not man-controlled temperature system, do not raise its temperature)
6