LevelOne WAP-6202 Quick Installation Manual page 3

LED / Button / Interface
LED / Button / Interface
Powered
WLAN
USB
Phone
PoE
RJ11 Block
Reset
The Device is powered LED will be on when AP is
powered on.
After the AP is powered on and wireless is enabled,
WLAN LED will blink when transmitting/receiving
wireless Data.
The USB port is used to charge external
devices(mobile phone, pads). The output Voltage is
5V 1A.
The Phone port is used to connect a telephone.
The PoE port is used to connect the power.
Power can be provided by a LevelOne PoE
Switch or a 802.3af Poe injector.
The LAN port is used to connect to network
LAN
devices, such as a switch.
The RJ11 block is used to connect to a 4-core
telephone cable.
With the AP powered on, press the Reset button
with a bent paperclip for 5 seconds until the
Link/Act LED goes off. The AP Will restart itself
and reset the device to factory default settings.
Description
3