Sangean DT-250 Manual
  1. Manuals
  2. Brands
  3. Sangean Manuals
  4. Radio
  5. DT-250
  6. Manual
Sangean DT-250 Manual

Sangean DT-250 Manual

Hide thumbs Also See for DT-250:
1
2
3
4
5
6
7
8
9

Advertisement

Table of Contents

DT-250
GB
Revision 1

Advertisement

Table of Contents
loading

Related Manuals for Sangean DT-250

Summary of Contents for Sangean DT-250

  • Page 1 DT-250 Revision 1...
  • Page 3 Controls Headphone/Antenna jack To improve FM reception during speaker use, leave headphones or external antenna device plugged in through headphone jack. Volume Control Rotate the volume control clockwise to increase volume, count- er-clockwise to decrease volume. Deep Bass Boost selector Deep Bass Boost provides better bass response.
  • Page 4 LCD display Memory Button/Clock Set Band Selection Tuning Up/Down My Favorites Lock Switch The lock switch is to prevent unintentional operation of your radio. To enable the lock function, slide the lock switch to the up posi- tion. When lock is activated, there will be a key icon shown on the display.

  • Page 5: Lcd Display

    LCD Display 90 minutes auto shut off Stereo icon Key locked Memory presets My favorite station Battery power indicator Frequency and Time Band...

  • Page 6: Battery Installation

    Battery Installation 1. Open the battery cover located on the radio of your radio by sliding in the direction shown by the arrows. 2. Insert two AA ( UM-3 ) size batteries, one in each compartment. Close the battery cover. 3. A flashing “ E ” appearing on the LCD display indicates a weak bat- tery and that replacement of batteries is required.
  • Page 7 Memory Tuning To tune in stations already programmed into memory. See Setting Memory instruction below on how to program stations into radio mem- ory. 1. Turn radio on. 2. P ress “ My Favorites “ button, MY will appear on the display indi- cating function is on. 3. Press Tuning control ( UP/DOWN ) to recall memory programmed stations.

  • Page 8: Setting The Clock

    Setting the Clock This radio features a clock that will display the current time while radio is off. To set the clock: 1. Turn radio off. 2. P ress and hold MEMO/CLOCK button until the hour setting begins blinking and the colon is no longer blinking. 3. Select hour by pressing the Tuning Controls ( UP/Down ) button until desired hour is displayed.

  • Page 9: Specifications

    Specifications Band Frequency: 522 – 1710 kHz FM 87.50 – 108 MHz Earphones jack: 3.5 mm mini-plug, 16 ohm impedance ( stereo ) Output Power: 60 mW (10% THD ) via built-in speaker Speaker: 1 3/8 inch diameter, 4 ohm impedance. Current consumption ( speaker output ): AM 60 mA FM 70 mA...

Table of Contents