Maintenance; Operation - Craftsman 315.EL2100 Operator's Manual

 Connect the other end of the USB cable (not provided)
to the USB dedicated charging port to begin charging
the device.
NOTE: The USB dedicated charging port provides
power only; it does not provide any communication
capabilities.
USING A BLUETOOTH
(NOT INCLUDED) WITH THE RADIO
See Figure 7, page iii.
 Press the MODE button until the ( ) BLUETOOTH
mode is highlighted.
 When the radio is switched to ( ) BLUETOOTH
the unit will attempt to pair to a BLUETOOTH
device and "bt" will flash in the LCD display.
NOTE: The radio will automatically attempt to connect
to the last device it was paired to. If a connection
cannot be established within five seconds, the radio
will make itself available to other BLUETOOTH
enabled devices.
 BLUETOOTH enabled devices must be within 30 ft. of
®
the radio and set to search/scan in order to pair with
the radio.
WARNING:
When servicing, use only identical
replacement parts. Use of any other parts could
create a hazard or cause product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.

OPERATION

ENABLED DEVICE
®
®
mode,
®
enabled
®
®

MAINTENANCE

 Select "Craftsman Radio" from your device's list of
available BLUETOOTH
and the radio. No password or PIN is required for
connection.
 When the device has successfully paired with the radio,
"bt" will stop flashing.
NOTE: When a device is paired to the radio,
information for connecting to the device is saved in the
radio's memory.
 When streaming audio from a BLUETOOTH
device, press the SCAN
the previous or next track. Briefly press and release the
PRESET button to cycle between pausing and playing
the audio.
NOTE: These controls may not be supported by the
BLUETOOTH
®
 All BLUETOOTH
normally while paired to the radio.
NOTE: Volume for any device paired to the radio can
be adjusted using the volume control for that device or
by using the radio's VOL + or VOL - button.
 To disconnect the BLUETOOTH
press and hold the PRESET button. When the device
is disconnected, "bt" will begin flashing in the LCD
display and the radio will begin searching for another
device.
WARNING:
gasoline, petroleum-based products, penetrating
oils, etc., come in contact with plastic parts.
Chemicals can damage, weaken or destroy plastic
which could result in serious personal injury.
Only the parts shown on the parts list are intended to
be repaired or replaced by the customer. All other parts
should be replaced by a qualified service dealer.
8 - English
signals to pair the device
®
or SCAN button to go to
device and/or application you are using.
enabled device controls can be used
®
enabled device,
®
Do not at any time let brake fluids,
enabled
®