FohFum Mo Assembly Manual

Cot

Hide thumbs

Table Of Contents

Quick Links

Download this manual

Assembly Guide

Table of Contents

Summary of Contents for FohFum Mo

Page 1 Assembly Guide...
Page 2: Table Of Contents
FohFumMo Congratulations! As the new owner of a FohFum cot you’re set to enjoy the peace of mind that comes with knowing you’re giving your baby the best sleeping environment possible. Follow the simple steps in this guide to assemble your cot, or convert your cot to a toddler bed.
Page 3: Components
TOOLS REQUIRED - Phillips Head Screwdriver - Allen Key (Supplied) Components PERSONS REQUIRED x 2 A. 1 x slatted bed base 8 x 50mm long jcb bolts 2 x bed ends 20 x 60mm long jcb bolts C. 4 x wooden legs G.
Page 4: A Attach Legs And Bed Ends To Base
Attach legs and bed ends to base ATTACH LEGS TO BASE Step 1 Clear yourself lots of clear floor space. Step 2 Attach the legs to the carrier rail on the underside of the bed base using the short (50mm) bolts and threading into the pre-inserted nuts. Ensure the legs slope outwards and the carrier rail sits in the recess in the top of the leg (Fig.1).
Page 5 Step 2 With the help of another person, attach the bed end to the bed base by threading the bolts into the nuts in the carrier rail (Fig.3). Leave bolts slightly loose until assembly is complete. To help the bolts locate the nut, support the weight of the bed end while you thread the bolt into the hole.
Page 6: B Attach Mesh Sides
Attach mesh sides Step 1 Select a mesh side. Step 2 Slide back sleeve to reveal the bottom rail (the 90mm high rail) and insert two nuts in each end. (Fig.1) Step 3 Place the bottom rail (inside the mesh sleeve) on the bed base carrier rail and align the bolt holes in the end of the rail with the corresponding bolt holes in the bed end (Fig.2).
Page 7 Figure 1 Figure 2 Figure 3...
Page 8: C Secure The Mesh Sides
Secure the mesh sides Step 1 The sleeves for the wooden dowels at each end of the mesh sides should have been pulled through the mesh slots in the bed end in the previous step. Insert the dowel into the sleeve to lock it in place (Fig.1). Use a tool such as one of the dowels or a wooden spoon handle to push the dowel home.
Page 9: Conversion To A Toddler Bed
Conversion to a toddler bed Step 1 Remove the dowels in the vertical mesh sleeves at the bed ends, and undo the bolts holding the 4 rails on (it helps to loosen the bolts on the bed base as well, in order to remove the rails). Tip: To remove the dowels use a tool such as another dowel or wooden spoon handle to push the dowel out of the sleeve.
Page 10: Care & Maintenance
Care & maintenance Important information! Read carefully and retain for future reference. Before using your FohFum cot, inspect CLEANING & MAINTENANCE it for damaged hardware, loose joints, To clean your cot use a damp cloth and missing parts or sharp edges.
Page 11: Safety Warnings
Safety warnings The cot should be converted to a This cot has been manufactured for toddler’s bed when the child is able use with a mattress which measures to climb out or reaches a height of 690mm wide by 1300mm long and 900mm.
Page 12 Designed & manufactured in New Zealand. ©2013 FohFum Limited PO Box 7033, Wellington 6242 New Zealand Phone: +64 4 389 0543 Email: hello@fohfum.co.nz FohFum cots are designed and tested to comply with the following safety standard: • The Australian and New Zealand Standard AS/NZS 2172:2010...