Advertisement
Controls and Indicators
Remote Panel
Volume Increase
Reverse Button
Forward Button
Play / Pause Button
Volume Decrease
™
(Hold 3 seconds for OFF)
Mounting Unit
3
P5
Side Panel
Power Button
AC Adaptor Jack
Speaker Cap
Using the iH85
Connecting iH85 to AC Power Source
Plug the AC adaptor cable into the
AC Adaptor Jack and the other end into a
standard 120 VAC wall socket. If an iPod is properly connected, it will begin charging,
indicated by a flashing LED. The iH85 also operates on 4 "AA" batteries (see page
4 for information on installing/replacing batteries) for portable playing. The AC adaptor
charges the iPod with or without batteries installed. The unit will not charge your iPod
while operating just on batteries.
NOTE: To save battery life, when running on Batteries, unit will automatically power
OFF after 2 hours of NON-use (no button activation). Press any button to
re-activate the unit.
Install iPod Insert
Your iH85 comes with 3 inserts to ensure your iPod fits properly on the dock located
inside the case. Not all iPod models require inserts. See Page 1 for insert table.
To place an insert:
1. Select the insert for your iPod. Using the correct insert ensure the proper fit to
your iPod.
2. Gently press the iPod insert into the insert.
3. Carefully place your iPod with insert into the dock. The iPod must not be in a
case or "skin".
NOTE: For nano models, dock the nano first, then slide insert over docked
nano
To check for iPod compatibility
iH85 is an advanced system and supports most updated iPod features. To have your iPod working properly with the iH85,
please update your iPod firmware with the latest one. Please check Apple website for the latest firmware.
Install/Replace the Remote Control Batteries
The remote control batteries are already installed at the factory. When the remote control
stops operating or its range seems reduced, replace the batteries with new ones.
1. The battery compartment cover is located on the bottom of the remote control.
2. Use a Phillips screwdriver to unscrew the retaining screw on the battery compartment
cover.
3. Turn the battery compartment cover counterclockwise slightly to unlock the battery cover.
Remove the cover.
4. Insert 2 CR2032 batteries, checking the + and – ends of the batteries match the diagram
inside the battery compartment.
5. Replace the battery cover, turn clockwise to lock and replace the retaining screw.
NOTE: Make sure you dispose of batteries properly (see your local regulations).
P6
4
Advertisement
