Table of Contents
Advertisement
Radiant / Convector Combination Heater
Instructions for Operation and Installation
(Read these instructions carefully and retain for further reference.)
A qualified electrician must carry out the electrical installation of this heater. The
Electrical installation must comply with current UK regulations. Any claim on the
warranty could be invalid if these requirements have not been met.
The Vitro-i
Models:
Vitro-i 750 Black
Vitro-i 1200 Black
VITRO
THIN MINERAL
Vitro-i 1600 Black
Vitro-i 750 White
Vitro-i 1200 White
Vitro-i 1600 White
NOTE:
1
Advertisement
Table of Contents
Related Manuals for Ducasa Vitro-i 750 Black
Summary of Contents for Ducasa Vitro-i 750 Black
- Page 1 The Vitro-i Radiant / Convector Combination Heater Instructions for Operation and Installation (Read these instructions carefully and retain for further reference.) Models: Vitro-i 750 Black Vitro-i 1200 Black VITRO THIN MINERAL Vitro-i 1600 Black Vitro-i 750 White Vitro-i 1200 White...
-
Page 3: General Information
GENERAL INFORMATION The Ducasa Vitro-i glass fronted designer heater provides a combination of radiant and convected heat and will grace any home. With an LCD display the Vitro-i can be used as a standalone heater, or used in conjunction with the Smart Command Heating Pack (optional). -
Page 5: Technical Data
LOCATION The ideal place to site the Ducasa heater is as close as possible to coolest wall in the room but it is not recommended to site the heater on un-insulated exterior walls, in this case, the part of the wall behind the heater should be insulated. -
Page 6: Control Options
Mounting the Heater In order to mount the appliance on a wall, it is necessary to first secure the support frame supplied with the appliance to the wall. Remove the support frame attached to the rear part of the appliance. To do this first press the two upper clips of the support frame in order to release the frame from the upper rear part of the appliance and then withdraw the lower part of the support frame. - Page 7 AUTO / MANUAL /OFF PROG When the heater is in Stand-by Mode it will retain programmes and continue to communicate with Ducasa Vitro-i Controls Gateway but will not heat. To switch the heater On again, press the MODE button to choose programme mode manual mode –...
- Page 8 When the temperature setup icon starts Manual Programming flashing, press OK to scroll through each mode. To assist with programming the LCD screen is backlit and will stay illuminated for approximately 10 seconds after the last button is pressed. When the heater is operational and the room temperature is lower than the set temperature the heating symbol will be shown indicating...
- Page 9 Programming with Smart Commmand To select one of the five advanced settings (C1 to C5) use the +/- keys and choose the required programme your Vitro-i with mode by pressing OK. The advanced settings are: Gateway you must pair the C1->...
- Page 10 Firmware Version (C4) Heater Reset It shows internal software installed in the Resetting the heater will return all settings to the electronics. factory defaults and will also delete any “pairing” with a Gateway. To activate the RESET feature press the OK button and the CONFIG button for 10 seconds.
-
Page 12: Maintenance And Care
This product should not be mixed with other commercial wastes for disposal. MAINTENANCE AND CARE Ducasa heaters require very little maintenance. The surfaces of the heater must not be cleaned with an abrasive product or those containing granular substances.
Need help?
Do you have a question about the Vitro-i 750 Black and is the answer not in the manual?
Questions and answers