Advertisement
Technical Information of Operation
Page 6
Alternatively, the kettle may be filled through the spout. The water level must be within the Min and the
Max level. Too little water will cause the kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when boiling.
Ensure that the lid is firmly in place before plugging the power outlet.
2. Position the kettle on the power base. Connect the plug into power outlet.
3. Press down the switch, the indicator will light up. Then start to boil the water, the kettle will switch off
automatically once the water has boiled. The kettle will not re-boil until the switch is pressed again. The
kettle may be stored on the power base when not in use.
：
，
NOTE
Ensure that switch is free of obstructions and the lid is firmly closed
The kettle will not turn off if
the switch is constrained or if the lid is opening.
4. If you want to make tea, open the carafe lid, take out filter canister from carafe, then put tea or a bag of
tea into the filter canister and place it back properly in the carafe, make sure the hole in the filter canister
aligns with the tuber on the handle of carafe.
5. Lift water kettle from power base and then pour boiled water carefully into carafe (the level of water
should not low than 0.6L), eventually close carafe lid.
①O
NOTE:
perate carefully when pouring the water from your kettle, as boiling water will scald, and press
the carafe lid when pouring to prevent the filter falling out. Don't open the lid while the water in the kettle is
hot.
②You can also pour boiled water into glass jug for keeping warm.
③
Normally, the glass jug handle is just above the kettle handle, you can turn the glass jug handle
clockwise and anticlockwise, but can't exceed the arrow mark on the kettle.
Advertisement
