Radio Transmission - Axis M3044-WV Installation Manual

reasonable protection against harmful interference
when the equipment is operated in a commercial
environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment in a
residential area is likely to cause harmful interference
in which case the user will be required to correct the
interference at his own expense.
Using a shielded network cable (STP) – This
equipment has also been tested using a shielded
network cable (STP) and found to comply with the
limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment
and receiver.
•
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
To be used in a residential area or a demanding
electrical environment, the product shall be
connected using a shielded network cable (STP) that
is properly grounded.
Canada
This digital apparatus complies with
CAN ICES-3 (Class B). The product shall be
connected using a shielded network cable (STP)
that is properly grounded. Cet appareil numérique
est conforme à la norme CAN NMB-3 (classe B). Le
produit doit être connecté à l'aide d'un câble réseau
blindé (STP) qui est correctement mis à la terre.
Europe
This digital equipment fulfills the requirements for RF
emission according to the Class B limit of EN 55032.
The product shall be connected using a shielded
network cable (STP) that is properly grounded.
Australia/New Zealand
This digital equipment fulfills the requirements
for RF emission according to the Class B limit of
AS/NZS CISPR 32. The product shall be connected
using a shielded network cable (STP) that is properly
grounded.
Japan
この装置は、クラスB 情報技術装置です。こ
の装置は、家庭環境で使⽤することを⽬ 的
としていますが、この装置がラジオやテレビ
ジョン受信機に近接して使⽤されると、 受信
障害を引き起こすことがあります。 取扱説明
書に従って正しい取り扱いをして下さい。 本
製品は、シールドネットワークケーブル(STP)
を使⽤して接続してください。また適切に
接地してください。
Korea
이 기기는 가정용(B급) 전자파적합기기로서
주로 가정에서 사용하는 것을 목적으로 하며,
모든 지역에서 사용할 수 있습니다. 적절히
접지된 STP (shielded twisted pair) 케이블을
사용하여 제품을 연결 하십시오.

Radio transmission

This equipment may generate or use radio frequency
energy. The user could lose the authority to operate
this equipment if an unauthorized change or
modification is made.
USA
This product complies with FCC radiation exposure
limits for an uncontrolled environment. This
equipment shall be installed and operated with a
minimum distance of 20 cm (7.9 in) between the user
and the device.
Canada
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may
not cause interference, and (2) this device must
accept any interference, including interference that
may cause undesired operation of the device.
This product complies with IC radiation exposure
limits for an uncontrolled environment. This
equipment shall be installed and operated with a
minimum distance of 20 cm (7.9 in) between the
user and the device. This device for operation in the
frequency band 5150-5250 MHz is only for indoor
use to reduce the potential for harmful interference
to co-channel mobile satellite systems.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil
doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Ce produit est conforme aux limites d'exposition aux
radiations IC pour un environnement non contrôlé.
L'équipement doit être installé et fonctionné à une
distance minimum de 20 cm (7,9 po) entre l'utilisateur
et le dispositif. Dans la bande de fréquences de
5 150 à 5 250 MHz, cet appareil doit uniquement
être utilisé à l'intérieur afin de réduire le risque de
brouillage préjudiciable de systèmes de service mobile
par satellite se trouvant dans le même canal.
Europe
Hereby, Axis Communications AB declares that