Advertisement
Quick Links
Advertisement
Summary of Contents for LAON TECHNOLOGY LTWI-BATCHG125
- Page 1 LTWI-BATCHG125 Battery Charger Operating Instructions LAON Technology o., Ltd. www.laon-tech.com...
- Page 2 INTRODUCTION The LTWI-BATCHG125 is a seven-bay charger for charging the LTWI-BAT50 and LTWI-BAT150 rechargeable battery packs. It is able to charge up to five Belt Packs and two LTWI-BAT50 rechargeable battery packs either separately or together. It takes approximately 4.5 hours to fully charge. Using the Belt Pack/LTWI-BAT150 two- way bays, up to two LTWI-BAT150 rechargeable battery packs can be charged instead of the two Belt Packs.
-
Page 3: Equipment Overview
EQUIPMENT OVERVIEW [Figure 1: LTWI-BATCHG125 Battery Charger] 1. Three stations for charging Belt Pack not separating the LTWI-BAT50 rechargeable battery pack from the Belt Pack body 2. Two stations for charging either Belt Packs or LTWI-BAT150 rechargeable battery pack 3. Two stations for charging LTWI-BAT50 rechargeable battery pack 4. - Page 4 Step 1: Plug the DC cable of the enclosed wall-adapter power supply into the 12V DC power connector (#11) on the rear panel of the LTWI-BATCHG125 unit. Plug the other end of the power code into a standard wall outlet.
- Page 5 [Figure 5: Put the Belt Pack into the charging bay (A) and or (B)] ALERT! Do not attempt to charge any batteries other than maker designated rechargeable NiMH batteries otherwise, it may cause damages. If you attempt to charge alkaline battery into the charger, a red charging LED will be blinking to alert a warning.
- Page 6 If the sensing LED in amber is steady on after a battery is inserted in a charging station, there may be a defect on either the rechargeable battery pack or LTWI-BATCHG125 battery charger. The issue may be detected with the following tests;...
- Page 7 ‘B’ works well, it indicates that the rechargeable battery pack ‘A’ is faulty. If the new battery pack ‘B’ fails in any bay the same, it indicates that the LTWI-BATCHG125 battery charger is faulty. NOTE: When the red charging LED blinks, the battery charger will quit the charging automatically. The LED keeps blinking if the battery is not removed.
-
Page 8: Technical Specfications
2.4V 2450mAH NiMH rechargeable battery pack Actual products and equipments may not be exactly as the figures and images used in this Operating Instruction and are subject to change without prior notice. LAON Technology Co., Ltd. may update this publication at its own discretion.