Advertisement
3.3 Terminal Cup Installation
With the speaker cabinet lying front face down, push the female terminals of the yellow+black
wires on to the terminal cup male terminals with the black wire connecting to the black binding
post and the yellow wire connecting to the red binding post.
Push the terminal cup into the rectangular opening on the back baffle and secure it with four
black #6 x 5/8" screws. Do not over-tighten the screws.
3.4 Port Tube Installation
Press fit the port tube into the round opening on the back baffle. Use only the back of your hand
to apply pressure. Ensure the port is fully pushed down on the back baffle surface such that
there is no gap between the port tube flange and the baffle surface as highlighted below.
Make Audio Annex Basic Kit Assembly Instructions
Revision 1.0
pg. 7
Advertisement
