Table of Contents
Advertisement
power tool. If it is damaged, the power tool must be repaired. Many
accidents are caused by using poorly maintained power tools.
Keep cutting tools sharp and clean. Properly maintained cutting tools with
sharp cutting edges are less likely to jam and are easier to control.
Use the power tool, accessories and cutting tools, etc., in accordance
with these instructions and in the manner intended for the particular
type of power tool, taking into account the working conditions and the
work which needs to be done. Using a power tool in ways for which it was
not intended can lead to potentially hazardous situations.
5.5
Service
Your power tool should be serviced by a qualified specialist using only
standard spare parts. This will ensure that it meets the required safety
standards.
6 MACHINE-SPECIFIC SAFETY WARNINGS
Hold tool by insulated grip surface when performing an operation where the
cutting tool may contact hidden wiring or its own cord. When in contact with a
live wire, metallic parts of the tool will also become live and may cause an
electric shock to the operator.
Do not start the tool with the blade touching any surface. The blade action will
bounce the tool and may cause body injury.
Allow the tool to come to a complete stop before putting it down. A running
tool will jerk when the blade tip contacts any surface.
Do not cut oversized work pieces
Do not cut nails or screws unless you are using a blade specifically designed
for this purpose. Inspect your material before cutting
Before switching on the tool, be sure the blade in not contacting the work
piece.
Keep hands away from moving parts and on the top surface of the work piece.
Do not place hands below work surface while saw is operating.
7 ASSEMBLY
Always check that the power supply corresponds to the voltage on the rating
name plate.
To avoid accidental start, check to make sure lock-on button is not engaged prior
to plugging in tool and you finger is not touching the ON/OFF switch trigger (4).
7.1
Install or remove the saw blade (Fig 1)
Unplug the power cord first.
Rotate the Quick-release blade clamp (2) anticlockwise with hand.
At the same time push blade (10) to the deepest position, then release the
quick-release blade clamp (2). Make sure it is securely fastened.
When removing the saw blade (10), follow the above procedure in reverse
order.
Before plugging in power cord, always pull on the blade (10) to
make sure it is securely locked in the clamp. Failure to do so
may result in serious injury.
Copyright © 2015
FX1-32
P a g e
| 5
EN
www.Ford-tools.com
Advertisement
Table of Contents
