Table of Contents
Advertisement
Quick Links
9
3
/
in. (90 mm)
16
USER'S GUIDE
1. Using a knife, cut the diagram out (cut on the outer part of the line).
2. Align the cut-out to your panel and draw cut marks.
3. Cut the hole in the panel to the precise dimensions of the cut-out:
3-9/16 in. x -3-9/16 in. (90 mm x 90 mm)
--> See the installation section for complete instructions.
PS-202
PANEL MOUNT DUAL DISPLAY
CONTACT DIAGRAM
TDS CONTROLLER
LINE 2 RELAY (SWITCH)
LINE 1 RELAY (SWITCH)
110-220V
N.C.
N.O.
N.C.
N.O.
AC
H
M
D I G I T A L
®
BLACK
RED
WHITE
BLACK
RED
WHITE
LINE 1 SENSOR (IN)
LINE 2 SENSOR (OUT)
www.ponpe.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for HM Digital PS-202
Summary of Contents for HM Digital PS-202
- Page 1 3. Cut the hole in the panel to the precise dimensions of the cut-out: 3-9/16 in. x -3-9/16 in. (90 mm x 90 mm) --> See the installation section for complete instructions. PS-202 PANEL MOUNT DUAL DISPLAY CONTACT DIAGRAM TDS CONTROLLER...
- Page 2 Thank you for purchasing HM Digital’s PS-202 The PS-202 is a dual display panel mount total dissolved solids (TDS) controller that monitors and controls levels of TDS in water. The controller has two independent maximum set point to help maintain a limit of TDS allowed in two water lines, such as the product water and the feed water.
- Page 3 ONE YEAR LIMITED WARRANTY power source. Incorrect connections could result in shorting out the unit. The PS-202, including the controller and both sensors, is warranted by HM Digital, Inc. 1. Remove the contents from the box. ("the Company") to the purchaser against defective materials and workmanship for 2.
- Page 4 If troubleshooting does not solve the problem, please contact HM Digital for assistance. If your controller is still under warranty, please return the controller to HM Digital for repair or replacement (see page 6). To calibrate: 1.
Need help?
Do you have a question about the PS-202 and is the answer not in the manual?
Questions and answers