Advertisement
Quick Links
Noble Digital Wedge Lock
Single User manuals Ver. 0.94 Dec., 2015
NOTE: Do not connect the lock to the computer via USB until instructed to do so.
SOFTWARE INSTALLATION
•
Go to
www.noblelocks-reg.com
•
Open download.
•
Select lock user , Download and install LaptopLockerUser.msi
•
Run SW from the Start Menu (After the first running, Laptop Locker runs in the background until a lock is
connected).
LOCK REGISTRATION
NOTE: Must be connected to the internet to register the lock, and to change the user password.
•
Connect the lock by the USB cable from the PC/Laptop USB port to the Micro USB port in the lock.
•
Lock should blink green when connected for the first time. (If the lock blinks fast red, it's a registered
lock.)
•
User Interface will open (Figure
•
Press the Register key on the upper right side
•
The Registration screen will open. (Figure 2)
ETZ08T
Noble Security Inc.
1).
Figure 1: Main screen when the lock is connected
Advertisement
Summary of Contents for Noble ETZ08T
- Page 1 Noble Digital Wedge Lock ETZ08T Noble Security Inc. Single User manuals Ver. 0.94 Dec., 2015 NOTE: Do not connect the lock to the computer via USB until instructed to do so. SOFTWARE INSTALLATION • Go to www.noblelocks-reg.com • Open download.
- Page 2 Figure 2: Registration screen • Fill all fields according to the following: • E-Mail – The email address you want to restore your lock password. • Phone – Your phone number to get SMS for restore password • Your password to open the lock. Password must have 8 - 20 any characters •...
- Page 3 Figure 4: After registration or change password screen • Enter your password, press UNLOCK and the lock indicator will light green. The unlock attempt was successful You may register and save this password at www.Noblelocks-Reg.com Note: No need to keep the USB connected-Use only when need to open the lock. •...
- Page 4 4. UNLOCKING • USB port in the lock. Connect the USB cable from the PC/Laptop USB port to the Micro • Popup screen will show (As figure 4). Fill Password and press UNLOCK. Green light will show for few seconds-You need to pull the lock Lever back to Open.(Now you can Coil and store the lock) •...
- Page 5 Figure 7: Forget password box Figure 8: Forget password text message example Change Password: • After Opening the Lock, enter new password. • Retype the new password. • While the lock indication light is Green, Press the Save password and verify message as in fig. 4.