Advertisement
Setup and Operation
4. How to Pair the Solar Audio Table
(I) To start the pairing process, press and hold the Bluetooth
rapidly indicating the unit is in standby mode for pairing.
(II) Start the Bluetooth
function on your device, locate Solar Audio Accent Table 0125 or Solar Audio Accent Table 0181
®
and connect to either one from your Bluetooth
(III) The LED will turn blue when paired.
(IV) For non-Bluetooth
devices, use the AUX cable provided.
®
Note:
1: If the pairing is not successful, power off the speaker, then power on the speaker and then re-pair once again.
2: After initial pairing success, paired devices will be stored in memory. Therefore, there is no need to go through the
pairing steps for future use. (Note: You will need to re-pair the device if the item is deleted from your device list.)
3: If you want to pair the speaker with another device, disconnect the Solar Audio Accent Table 0125 or Solar Audio
Accent Table 0181 with existing paired device by pressing (button as shown)
the steps 1-3 as indicated above.
5. How to Use the AUX Port (for non-Bluetooth
(I) Using the AUX cable (included), you can connect the Solar Audio Accent Table 0125 and Solar Audio Accent Table
0181 to the AUX port on any music device.
(II) Play music through the connected devices.
Note: Only the "Volume+/-" and "LED-lighting" function works in AUX mode.
Page 4
wireless technology button, the blue and red LEDs will blink
®
device(s) list.
®
AUX IN
DC
enabled devices)
®
, then pair with a new device, following
Advertisement
