Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for auto maskin NMEA2000/J1939
- Page 1 Manual# 1140131 Quick Installation Guide Gateway NMEA2000/J1939...
- Page 3 Quick Installation Guide Gateway – NMEA2000/J1939 Printed May 2016 Revision Revised www.auto-maskin.com...
- Page 4 Copyright © 2013 - 2016 by Auto-Maskin AS. All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Auto-Maskin AS. Page ii Quick Installation Guide...
-
Page 5: Table Of Contents
Table of Content DOCUMENT INFORMATION ........ 1 ..........1 BOUT THIS MANUAL Responsibilities ..........1 INTRODUCTION ........... 2 ..........2 IRMWARE EVISIONS ..........2 RODUCT EATURES INSTALLATION OF THE GATEWAY ......3 ..........3 NPACKING THE BOX ..........3 OUNTING THE UNIT NMEA2000®... -
Page 7: Document Information
For updated information, please Document contact your local distributor. Information About this manual This manual has been published primarily for professionals and qualified personnel. The user of this material is assumed to have basic knowledge in marine systems, and must be able to carry out related electrical work. -
Page 8: Introduction
User settable NMEA GPS Device Introduction Instance using rotary switch Blue LED confirming NMEA GPS The Auto-Maskin NMEA2000® to data reception J1939 CANbus Gateway is designed to NMEA2000® interface optically convert Latitude, Longitude, Compass isolated from the J1939 CANbus Direction and Vehicle Speed messages Power drawn only from the ... -
Page 9: Installation Of The Gateway
Installation of Connecting the the Gateway NMEA2000® cable The unit shall be connected to the This chapter covers installation of the NMEA2000® network by the 5-way Gateway. micro C socket on the front. Carefully attach the network drop- Unpacking the box cable to this plug and hand-tighten until it is fully seated. -
Page 10: J1939 Canbus Connections
The wire shall be stripped 8 mm and then the cage clamp shall be opened with a small screwdriver in the slot above the wire connection. Then, simply insert the wire into its connection slot and release the cage clamp by removing the small screwdriver. -
Page 11: Configuration
Valid GPS Instances range from “0” Configuration through to “F”. If the Gateway does not receive any The following two items can be data from a GPS device with the configured directly on the Gateway selected GPS Device Instance for more using the two small rotary switches. -
Page 12: Front Panel Indicators
Front Panel Indicators Blue LED The left-hand side blue LED flashes on NMEA2000® transmits, and every 2.5 seconds while receiving valid GPS data. Green LED The right-hand side green LED flashes only on transmission of J1939 CANbus messages, which is every second. Page 6 Quick Installation Guide... -
Page 13: Maintenance
Maintenance Clean the unit with a soft cloth. Do not use chemicals cleaners as they may remove paint or markings, or may corrode the enclosure or seals. Ensure that the unit is mounted securely and cannot be moved relative to the mounting surface.
Need help?
Do you have a question about the NMEA2000/J1939 and is the answer not in the manual?
Questions and answers