Before Using; Components; Charging The Batteries; Getting Started With The Scala-700 - Cardo Systems Scala 700 User Manual

4. Before Using

Components

Charging the Batteries

Make sure the headset is fully charged prior to
initial use. Allow 4 hours for a full charge
before using for the first time. Normally allow
for approximately 2-3 hours to complete a full
charge.
1. Connect the headset to the wall
charger or the optional car-charger
2. The Indicator Light on the scala-700
will turn red
commences. Allow the headset to
charge until the Indicator Light turns
off.
3. When charging begins, the headset is
automatically turned off. You must
turn it on again if you wish to use it
after charging.
when charging
4
5. Getting Started
With the scala-700

Turn On/Off

To turn ON the Headset, press and hold the
wheel for at least 3 seconds until an ascending
tone is heard, and a blue indicator light flashes
3 times. Release the button. The blue light will
flash every 3 seconds to indicate that the
device is in standby mode.
To turn OFF the Headset, press and hold the
wheel for at least 3 seconds until a red flashes
3 times and a tone is heard. Release the button.

Pairing

Pairing is a required process in which the
scala-700 headset and your mobile phone
become acquainted with each other for the first
time. At the end of this process both devices
retain information about each other, so that
every time you turn one of them on, it will
look for the other device and will be able to
operate automatically with it. Pairing is
required only the first time for a specific scala-
700 headset and a specific mobile phone.
Please refer to the Pairing section of your
mobile phone's manual prior to initiating the
process.
NOTE: If, after your devices are paired, you
wish to use your headset with a different phone,
you must pair the headset to the new phone.

How to pair:

1. Turn on the phone and make sure its
Bluetooth function is activated.
2. Make sure the headset is turned off.
3. Press and hold the Wheel for about 8
seconds until the red and blue LEDs
start flashing rapidly.
4. On your Bluetooth equipped phone,
search for Bluetooth devices by
following your phone's instructions.
Usually this is done by selecting the
Search or Discover option in the
Bluetooth or Connection menu. Refer
to your phone's manual for detailed
instructions on how to pair your
specific phone.
5. After a few seconds of searching,
your phone will list the "scala-700"
as a discovered device. Select it, and
when asked, follow your phone's
instructions to select the device.