Contents Guide to the Appliance Caring for the Environment Safety Information and Warnings Items in the Box Getting Started Basic Set Up Operation Instructions Troubleshooting Care and Maintenance Technical Specifications...
Guide to the Appliance Detergent Control Drawer Drain Panel Hose Power Plug Door Service Panel Control Panel 1200 No Spin NOTE: Due to production improvements, the appliance may differ slightly from the diagram shown. Diagrams in this instruction manual are for reference only.
Caring for the Environment Responsible disposal of the packaging The packaging of your appliance has been selected from environmentally friendly materials and can usually be recycled. Please ensure these are disposed of correctly. Plastic wrapping can be a suffocation hazard for babies and young children, please ensure all packaging materials are out of reach and are safely disposed of.
Safety Information and Warnings For your continued safety and to reduce the risk of injury or electric shock, please follow all the safety precautions listed below. WARNING! • If you will not be using the washing machine for a while such as when you go on holiday, disconnect the plug from the mains supply and turn off the water supply to the washing machine.
Page 6
Safety Information and Warnings • If you disconnect the mains plug, hold onto the mains plug not the cable. Pulling the cable may cause an electric shock or a fire. • Do not use a mains plug adapter or extension cable. It may overheat and cause a fire. •...
Items in the Box Remove all items from the packaging. Retain the packaging. If you dispose of it please do so according to local regulations. The following items are included: Transport Hole Plug Main unit Water Supply Drain Hose Hose Support In st ru ct io n M an ua l...
Getting Started Please Read And Follow The Instructions Carefully. • In addition to the instructions mentioned here, special regulations of the relevant water and power supply companies may apply. If in doubt, have the washing machine connected by a qualified technician. •...
Getting Started To remove the transport bolts: 1. Use a spanner to loosen the bolts. They are located at the rear of the washing machine. 2. Pull the bolts out horizontally. Make sure the entire bolt is removed. 3. Push the transport hole plugs (included with your accessories) into the respective bolt holes.
Basic Set Up Connecting the water supply hose 1. To prevent leakage from 3/4” 3/4” connection joints, ensure the rubber washer seals are fitted to each end of the water supply hose. Do not use without the seals in place. 2.
Basic Set Up Draining to a sink or wash-basin • Secure the drain hose in position, so it can’t drop Drain Hose out of the basin. Support • Don’t block the basin’s drain outlet, and make sure that the drainage through it is sufficient to prevent overflowing.
Operation Instructions Organising laundry • Read the washing label on each garment to help you sort your washing into different loads. • Sort the laundry by colour, type of fabric and by how soiled it is. This will help you choose the correct program and temperature for each wash.
Operation Instructions Adding detergent and softener • Add detergent into compartment (II) of the detergent drawer. Main wash Detergent detergent • Add softener into the softener compartment before you start washing. Softener Softener • Apply detergent and softener according to the Pre-wash Detergent washing amount, the soiling level, the water...
Operation Instructions Before first use Before washing your clothes for the first time, run a full wash program first: 1. Connect the machine to the mains power supply and the water supply. 2. Put a small amount of detergent in the detergent drawer. Close the drawer. 3.
Page 15
Operation Instructions Selecting the program Program Description Max. Water temperature Default Program load (°C) spin time (kg) speed (minutes) (rpm) Default Optional Cotton For daily 1200 washable items Cold Cotton For daily 1200 Intensive washable items 90, Cold with additional washing time Quick For few and...
Page 16
Operation Instructions NOTE: For reference only; the actual program time may vary, depending on the different parameters such as the water temperature selected and the weight of load. Cotton Intensive with 60°C water temperature and spin speed 1200 rpm selected is the recommended for 5.0 kg normally soiled cotton load, which is the energy and water rating label program tested to AS/NZS 2040.1 requirements.
• Power is disconnected. • Check if the power is shut down and Indicator or • PC board has power plug is connected correctly. display does not problems. light • If not, contact GVA customer care. • Harness has connection problem.
Page 18
Troubleshooting Issues Reasons Solutions • Washing powder is dampened and • Clean and wipe the box. agglomerated. • Use liquid detergents or change Detergent • Too much detergent. residues in the detergent was • Use less detergent. used. • Dilute liquid detergent. •...
• Check if the door of the washing machine is closed. Temp 20˚ Door lock problem flashing • Check if the clothes are pinned by the door. • Call GVA customer care if there are still problems with the Others machine.
Care and Maintenance IMPORTANT: Always unplug the washing machine before cleaning. Cleaning the drum • Any rust left inside the drum by metal articles must be removed immediately with chlorine-free detergent. • Never use steel wool. Cleaning the exterior of your washing machine •...
Care and Maintenance Cleaning the door seal and window • Wipe the window and seal after each wash to remove lint and stains. If lint builds up, it can cause leaks. • Remove any coins, buttons and other objects from the door seal after each wash. Cleaning the drain filter IMPORTANT: •...
Care and Maintenance Preventing a frozen water supply hose If your washing machine is delivered in freezing weather conditions, leave it at room temperature for 24 hours after you’ve set it up before using it. This ensures there’s no ice blocking the water supply hose. If your water supply hose freezes, add 2 or 3 litres of warm water to the drum and wait for 10 minutes.
Technical Specifications Model G5FLWW15 Rated Voltage 220-240 V~ 50 Hz Rated Power 2100 W Maximum Input Current 10 A Inlet Water Pressure 0.05 MPa - 1 MPa Dry Cloth Capacity Maximum 5.0 kg Dimensions (H) x (W) x (D) Approximately 850 x 595 x 470 mm...
Page 24
M.E.W. (Australia) Pty Ltd 15 Vaughan Street Essendon Fields VIC 3041 ACN 152 719 036 1300 725 885 customercare@gvaproducts.com.au gvaproducts.com.au While every effort has been made in the preparation of this instruction manual, the publishers cannot be held responsible for the accuracy of the information contained herein or any consequences arising from it.
Need help?
Do you have a question about the G5FLWW15 and is the answer not in the manual?
Questions and answers