Table of Contents
Advertisement
VRZ241(H1795).QX33
4/9/99 9:17 AM
Setting Up the VCR Plus+ Programming System (cont'd) 35
2
Now, compare the channel numbers you have written in the VCR
PLUS+ CH. and CABLE/TV CH. columns. For stations whose VCR
Plus+ and Cable/TV channels do not match, you must tell the VCR
the VCR Plus+ and Cable/TV channel numbers by following steps
3 - 7. Make each entry within 60 seconds of the previous entry.
3
Press the VCR button, then press the MENU button.
4
Press the PLAY/o button or the STOP/p button to select
VCR SET UP, then press the F.FWD/B button.
SELECT op CHOOSE B
REPEAT PLAY
OFF
ON SCREEN MODE
LANGUAGE
VCR PLUS+ REF. MAP
TO END PUSH EXIT
5
Press the PLAY/o button or the STOP/p button to select
VCR PLUS+ REF. MAP, then press the F.FWD/B button.
VCR PLUS+ CROSS REF. MAP
VCR PLUS+
CABLE/TV
98
98
99
99
1
– – – – – >
1
2
2
TO SELECT CH PUSH op
THEN ENTER CH NO.
TO END PUSH EXIT
6
Look at the lists you filled in on page 34. For stations whose
VCR Plus+ and Cable/TV channels do not match, press
the PLAY/o button or the STOP/p button until the
arrow is beside the VCR Plus+ channel you need. Then,
press the Number buttons to enter the corresponding
Cable/TV channel from your list. (Enter a "0" before single-
digit channels.) Enter all the stations on your list.
Note: If you are using a Cable Box/DBS, the Cable/TV channel will
be 03 or 04 (the Cable Box/DBS output channel) for every VCR
Plus+ channel. You must set the Cable Box/DBS to the channel
you want to record; leave the Cable Box/DBS on for the timer
recording.
VCR PLUS+ CROSS REF. MAP
VCR PLUS+
CABLE/TV
98
98
99
99
1
– – – – – > 23
2
2
TO SELECT CH PUSH op
THEN ENTER CH NO.
TO END PUSH EXIT
7
Press the STATUS/EXIT button.
Page 35
2
Examine the lists on
page 34.
4-5
2
3
1
5
6
4
8
9
7
0
+100
6
PLAY
REW
F.FWD
STOP
3
7
Helpful Hints
• To erase a Cable/TV channel num-
ber, repeat steps 3-5 on this page.
Then, press the PLAY/o button or
the STOP/p button to select it.
Press the CLEAR button, then press
the STATUS/EXIT button.
• To select line input for the Cable/TV
channel, press 0,0. AUX will appear
on-screen.
• When you receive the VCR, all the
VCR Plus+ channel numbers and
Cable/TV channel numbers are the
same.
Advertisement
Table of Contents
