Advertisement
Dimplex
Model : EvoRad2E
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Model
Description
EvoRad2E
2kW Oil free radiator with Electronic Thermostat
Important Safety Advice
IMPORTANT: If the appliance is damaged,
check immediately with the supplier before
installation and operation.
This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience or knowledge if they
have been given supervision or instruction
concerning the use of the appliance in a safe
way and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be
made by children without supervision.
Children of less than 3 years should be kept
away unless continuously supervised. Children
aged from 3 years and less than 8 years shall
only switch on/off the appliance provided that
it has been placed or installed in its intended
normal operating position and they have been
given supervision or instruction concerning
the use of the appliance in a safe way and
understand the hazards involved. Children
aged from 3 years and less than 8 years shall
not plug in, regulate and clean the appliance
or perform user maintenance.
CAUTION: Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and
vulnerable people are present.
This heater carries the warning symbol
indicating that it must not be covered.
DO NOT use the heater in the immediate
surroundings of a bath, a shower or a swimming
pool.
WARNING: This heater must not be used in
a bathroom.
DO NOT place the heater directly below a fixed
socket outlet.
WARNING: In order to avoid overheating, do
not cover the heater.
We recommend that you open a window to
ventilate the room when using the heater for
the first time.
Unplug the heater when not required for long
periods.
IMPORTANT: If the mains lead of this appliance
is damaged, it must be replaced by the
manufacturer or its service agent or a similarly
Watts
qualified person in order to avoid a hazard.
2000
DO NOT use the heater where gas, petrol, paint
or other inflammable goods are used or stored.
The heater is designed for operation on an AC electricity supply, and is suitable
for use in domestic dwellings and similar indoor locations.
Always ensure that the appliance is stood on a firm, level base near to, but
not directly beneath, a suitable fixed socket outlet.
The heater is fitted with castors and a handle for ease of movement.
It is supplied with a cord and plug ready for use.
The supply cord should be uncoiled before use (see 'Storage').
DO NOT pull the heater along by the mains lead.
Important - The heater must only be operated with the wheels and castors
fitted and in the upright position as shown in Fig. 1.
Warning – The heater complies with stringent safety standards but to ensure
efficient operation SURFACES OF THE HEATER WILL BECOME HOT
AND CONTACT WITH THESE AREAS SHOULD BE AVOIDED, particularly
between the fins on the top and sides.
Electrical
WARNING – THIS APPLIANCE MUST BE EARTHED
If the socket outlets in your home are not of the 13 amp BS1363 type they
will not accept the plug connected to this heater, therefore cut off the plug.
When cut off this plug can constitute a shock hazard if inserted into a socket
outlet. It must therefore be disposed of safely.
Before wiring the appropriate plug please note that the wires in this mains
lead are coloured in accordance with the following code:
GREEN/YELLOW:
BLUE:
BROWN:
Connect the Green/Yellow wire to the terminal marked E or the earth symbol
or coloured Green or Green/Yellow.
Connect the Brown wire to the terminal marked L or coloured Red.
Connect the Blue wire to the terminal marked N or coloured Black. DO NOT
connect the Brown (Live) or the Blue (Neutral) wires to the Earth terminal of
your 13 amp plug. If the terminals of the plug are unmarked or you are in
any doubt, consult a qualified electrician.
Fitting the castors
IMPORTANT: The castors should only be fitted to the outer fins (as shown
in Fig. 2). Fitting the castors to any other fin may result in the product
becoming unstable and may topple over during operation.
WARNING: THE HEATER IS HEAVY – TAKE CARE WHEN LIFTING AND
ENSURE THAT IT IS SUPPORTED DURING ASSEMBLY TO PREVENT
IT FROM TOPPLING.
Remove the carton containing the castor assemblies from the packing.
Turn the heater upside down on a carpet or other soft surface to avoid damage
If required request the assistance of a second person. Position a castor bracket
onto the outer fin and secure in place using the screws provided (see Fig. 2).
Repeat the process for the other castor, ensuring it is located on the other
end fin.
Lift the heater clear of the floor, then turn it back upright and stand it on its
castors as shown in Fig. 1. It is now ready for use.
Positioning the Heater
Select the position for the heater ensuring there is clearance from any furniture
and fittings of at least 300mm above the heater and 150mm each side. The
heater should only be operated on a flat stable surface.
Operating the Heater - 'Control Mode'
With the product plugged in, press the ''
neon and also light up the LCD display. This indicates that the product is in
control mode, the desired room temperature can then be set.
Setting the 'Desired' Room Temperature
The temperature is set using the temperature increase '
decrease '
' keys - see Fig. 2. The room temperature can be set in the
range between 5°C to 30°C. The back light of the LCD will change colour
depending on the desired room temperature. (Blue screen 5 to 16, 17 to 19
green, 20 to 22 white, 23- 30 red). Please note the temperature setting is for
desired room temperature (not the actual room temperature).
'Intelligent' Eco Mode
This is the appliance default setting, the appliance will automatically start up
in this setting once power is applied and the standby key is pressed. The
LCD display will indicate the desired room temperature and the appliance
will automatically regulate the room temperature accordingly. In this mode
the appliance operates at full power, however the output of the appliance is
automatically reduced and regulated as the room temperature approaches
EARTH
NEUTRAL
LIVE
' button. This will illuminate the
' and temperature
Advertisement
