Advertisement
Mobile Wireless System
1
Package Contents
MWS100 Mobile Wireless System
1.
Fused Power Cable (3A Slo-Blo fuse included)
2.
MWS100 Installation Guide (this document)
3.
Other accessories may be provided by your supplier or system integrator. To
complete the installation of the MWS100, the following items will be required:
1. Antenna(s). The MWS100 contains two 802.11 (Wi-Fi) radios. The first
radio operates in the 2.4 GHz band. The second radio operates in the 5
GHz band. Specific frequencies used are country / model dependent.
One antenna is required for each band you will be operating on.
2. Antenna Cable(s). A suitable length of antenna cable is required for
each antenna. Type LMR-200 cable is recommended with R-SMA
connectors for attachment to the MWS100.
3. Mounting Hardware. Suitable mounting hardware must be provided
depending upon specific installation requirements.
MWS100 Installation Guide
MWS100
Installation Guide
Page 1 of 5
Revision D3
4/14/2008
Advertisement
Table of Contents
Related Manuals for Strix Systems MWS 100
Summary of Contents for Strix Systems MWS 100
- Page 1 Mobile Wireless System MWS100 Installation Guide Package Contents MWS100 Mobile Wireless System Fused Power Cable (3A Slo-Blo fuse included) MWS100 Installation Guide (this document) Other accessories may be provided by your supplier or system integrator. To complete the installation of the MWS100, the following items will be required: 1.
- Page 2 Front Panel Indicators PWR LED – This indicator displays the status of the MWS100 power source. It will illuminate when power is applied top the unit. SIG LED – This indicator displays the operational status of the MWS100 radios. Rapid blinking (4 blinks per second) indicates that the radios are beginning operation (rebooting).
- Page 3 Rear Panel Connectors PWR – Attach the supplied fused power cable. RST – Performs a restart. LAN – 10/100 BASE-T Ethernet with 802.3af PoE input. AUX – R-SMA secondary antenna connector. MAIN – R-SMA primary antenna connector. MWS100 Installation Guide Page 3 of 5 Revision D3 4/14/2008...
- Page 4 Installation Note: The MWS100 must be installed by a trained professional installer only. Failure to comply fully with these instructions may void the MWS100 warranty and/or violate local safety or radio regulations. 1. Select a mounting location for the MWS100. The MWS100 is designed for mounting in an interior compartment or trunk of an automobile.
- Page 5 4. Using the supplied fused power cable, connect the BLACK wire to the vehicle ground and then attach the RED wire to the vehicle positive DC supply. The MWS100 is designed to operate from a minimum of 11 VDC * to a maximum of 52 VDC and a maximum current draw of 2 A.
Need help?
Do you have a question about the MWS 100 and is the answer not in the manual?
Questions and answers