The Contour is designed for licensed therapists and technicians and is intended to be used in a professional spa, salon, or similar commercial environment. While no special training is needed to operate the product, for safety reasons it is important that the instructions contained in this manual are reviewed in detail before the first use.
Avoid positioning the cord in the traffi c lane and it is always kept out of the way. Read all instructions before using the Contour pedicure chair. Take this furnishing out of service immediately if the cord or plug becomes damaged in any way.
Control Panel Operation Sanijet® Pipeless Jets Your Contour control panel is connected and ready for use. See below for descriptions of Pressing the On/Off button once will start the jets, and pressing the button again will turn the each button functionality. For the top row of buttons, push and hold the button until the system off.
SECTION 3: OPERATING INSTRUCTIONS SECTION 3: OPERATING INSTRUCTIONS Water Fill Valve Relaxor® Heat & Massage (Optional) The following diagrams illustrate the ease-of-use and functionality that the Relaxor® system The water fill valve is OFF when pointing DOWN. Water dispenses when you pull the valve UP. provides to you and your clients.
SECTION 4: CARE & MAINTENANCE SECTION 4: CARE & MAINTENANCE Cleaning Sanijet® Pipeless Jets Cleaning & Ongoing Maintenance CAUTION DANGER: RISK OF ELECTRIC SHOCK - Always refer to your state and local codes for specific cleaning requirements. Always unplug this furnishing from the electrical outlet before cleaning. - NEVER USE abrasive cleaners on any surface area.
Spec North America Europe/Asia problem with your product, determine possible causes, and find a solution. In the event your specific situation is not covered in this guide, please contact Living Earth Crafts Input Voltage 120 VAC 220 VAC so our technical support department can assist you. Beyond the troubleshooting guide below, do not attempt to repair the issue yourself.
Warranty Information Does the Contour have GFI/GFCI built in? Living Earth Crafts (LEC) offers an industry best warranty against defects in materials, design, There are no GFI/GFCIs built in to the system - we require a GFCI protected grounded circuit to and workmanship, to the original owner, as follows: supply power to the Contour.