Time Search 39 - Philips SV2000 Owner's Manual

SVZ142.comb 4/7/99 6:30 PM
The Time Search function allows you to go to a specific point on a
tape. You will enter the exact amount of playback time that you
wish to skip in order to reach the specified point.
Make sure:
The VCR is on and is in VCR position. (The VCR/TV light will
appear. If it does not, press the VCR/TV button once.)
There is a tape in the VCR.
1
Press the MENU button repeatedly until the SEARCH
SELECT menu appears.
SEARCH SELECT
QUICK-FIND
INDEX SEARCH
TIME SEARCH
2
Press the PLAY button or the STOP button repeatedly to
select TIME SEARCH. Then, press the F.FWD button.
TIME SEARCH
- : - -
3
Within 30 seconds, press the PLAY button or the STOP
button repeatedly until your desired length of time
appears. (Example: 2:50 for 2 hours 50 minutes) You may also
press and hold the PLAY button or the STOP button until you
reach the desired length of time.
4
Within 30 seconds, press the REWIND button or the
F.FWD button. The VCR begins rewinding or fast forwarding to
the specified point. The time counts down on-screen beneath
TIME SEARCH as the searching progresses. When 0:00 appears
beneath TIME SEARCH, the VCR will start playback automatically.
Page 39

Time Search 39

POWER VCR/TV EJECT
1 2 3
4 5 6
7 8 9
CHANNEL
0 +100
SPEED
1
SEARCH
QUICK-
SLOW TIME INDEX
FIND
MENU
DISPLAY EXIT COUNTER
4
RESET MEMORY
REWIND / PLAY F.FWD
/ STOP
RECORD PAUSE/STILL
3
Helpful Hints
• You may also activate the Time
Search by pressing the TIME
SEARCH button. Then, continue
from step 3.
• You can set a Time Search for up
to 9 hours, 59 minutes (9:59).
• Time Search is not available during
recording.
• To exit Time Search mode, press
the COUNTER RESET/EXIT button.
• To cancel a Time Search already in
progress, press the STOP button.
2