Subscribe to Our Youtube Channel
Related Manuals for Promowide SP1290
Summary of Contents for Promowide SP1290
- Page 1 SP1290 (SP1291 + SP1292 + HP1294) 900MHz Wireless Combo Speaker with Headphone...
- Page 2 User’s Manual Please read before using the equipment...
-
Page 3: Important Safety Information
INTRODUCTION This 900 MHz wireless combo speaker system with headphone uses the latest wireless technology that enables you to enjoy music and TV sound anywhere inside your home. You can simply connect the system to any audio source such as Radio, TV, VCR, Hi-Fi and CD/MP3/VCD/DVD player. - Page 4 8. Do not place this product on an unstable cart, stand or table. The product may fall, causing serious damage. 9. Do not allow anything to rest on the AC/DC adapter cord or AUDIO IN cable. Do not place this product where the cord can be abused by animals or people walking on it.
- Page 5 COMBO SYSTEM PART LIST DIAGRAMS & NUMBERING A) TRANSMITTER B) SPEAKER RECEIVER C) HEADPHONE RECEIVER D) ACCESSORIES...
- Page 6 COMBO SYSTEM PART LIST IDENTIFICATION Parts Identification: A: Transmitter 1. Power On/Off Indicator. 2. Audio cable. 3. Charging cable. 4. Channel selector (channel 2-1) 5. DC IN socket. 6. Antenna. B. Speakers 7. Power ON/Off Indicator. 8. Volume control/ Power ON/OFF. 9.
-
Page 7: Installation
26. Two rechargeable batteries (AAA size). INSTALLATION TRANSMITTER 1. Insert the antenna tube into the antenna wire. 2. Connect the supplied AC/DC power adapter to an electrical wall outlet. 3. Plug the AC/DC power adapter in the DC jack located on the rear of the transmitter. -
Page 8: Wireless Headphone
WIRELESS HEADPHONE 1. Open the battery compartment cover on the right side of the headphone. 2. Insert 2pcs of AAA size rechargeable batteries (supplied in the package) by matching the + and – on the battery to the diagram inside the battery compartment. - Page 9 For Speakers 1. Turn on the ON/OFF button on the speakers. Press the “AUTO-SCAN” button to get the best tuning reception in the speakers. When the button is pressed, frequency tuning starts automatically and it stops when a signal is detected. 2.
- Page 10 and then press the “AUTO-SCAN” button on the headphone again. 4. . Charging the Batteries a) Move the ON/ OFF switch on the headphones to OFF. b) Plug the charging cable on one end into the jack marked CHG at the back of the wireless transmitter (as shown in the picture below).
- Page 11 source for 4 minutes. If the audio signal comes back, the transmitter will turn on automatically. b) Turn off the speaker by tuning the volume control the OFF position. c) Turn off the headphone by switching the On/Off control. TROUBLE SHOOTING NO SOUND Ensure the AC/DC adapter is fully inserted into the AC outlet and the power connection input on the transmitter.
- Page 12 matching the frequency of the transmitter. Change the position of the channel selector on the transmitter. Press the “AUTO-SCAN” button on the speaker/headphone. Ensure the volume level of speakers/headphone is adjusted properly. The speakers/headphone is too far away from the transmitter, move it closer.
-
Page 13: Technical Specifications
TECHNICAL SPECIFICATIONS Transmission Mode UHF stereo Carrier Frequency 900 MHz Operation Voltage Transmitter, DC 12.5V 150mA Speaker, 6 x AA size Alkaline batteries (not included) or 12V 500mA 2x AC/DC adapters (included) Headphones, 2 x AAA size Rechargeable batteries (included) Frequency Response 40Hz –...
Need help?
Do you have a question about the SP1290 and is the answer not in the manual?
Questions and answers