Spektrum SPMVR2520 Instruction Manual page 14

Head Tracking
Wired Head Tracking
Most radio systems will connect to the optional cables for wired head tracking, but
many lack the programming functions to have both head tracking and fl ight controls
operating at the same time. Consult the radio system manual for information on trainer
or buddy box features.
Available option parts (not included) include FSV2113 for Spektrum/JR and FSV2112
for Futaba to connect the data port on the headset and the trainer port on common RC
control transmitters.
Wired Head Tracker Settings
NOTICE: For proper wireless head tracker operation, beep code menu points 1, 2, 3,
9 and 10 must be in a default state. If you are having problems with wireless head
tracking, restore the head tracker settings to factory defaults with menu point 11.
One advantage of using Spektrum AirWare radios for head tracking is there is little
to no reason to use the head tracking menu in the headset. For most adjustments it
is easier to make the changes in the radio system. This also enables one common
confi guration in the headset and individual model confi guration needs are handled on
the radio side.
To enter the head tracking menu, hold the Head Tracking button (HT) while inserting the
battery connector and immediately release the button after barrel insertion. The head-
set emits a series of short and long beeps to indicate menu options. Follow along and
read the navigation menu as you listen to the beeps. Press the HT button immediately
after the tone indicates the menu point you wish to select.
Menu points with multiple options have a sub menu. Upon pressing the HT button at these
menu points, the headset will emit a long beep to indicate a sub menu has been selected
and then proceed with a short beep to indicate the fi rst option in the sub menu.
Beep Code Menu Navigation
1. 1 short beep: Pan/Tilt/Roll on ch 5/6/7
2. 2 short beeps: Pan/Tilt/Roll on ch 6/7/8
3. 3 short beeps: Pan/Tilt only (no roll) output channel options
Long beep upon entering sub menu
1 short beep: Pan/Tilt only on ch 5/6
2 short beeps: Pan/Tilt only on ch 5/7
3 short beeps: Pan/Tilt only on ch 5/8
4 short beeps: Pan/Tilt only on ch 6/7
5 short beeps: Pan/Tilt only on ch 6/8
6 short beeps: Pan/Tilt only on ch 7/8
No selection: exit menu
14