Table of Contents
Advertisement
SF-150
Installation
Remove all packing materials from the SF-150. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Mounting the Wheels and the Rubber Feet
Fig. 02
01) Install both wheels (02) to the wheel shaft, by means of the 2 screws (01).
02) Install the rubber feet brackets (03) to the fan, by means of the 2 screws (04).
03) Thread both rubber feet (05) to the brackets.
Ordercode: 80376
7
Advertisement
Table of Contents
