Table of Contents
Advertisement
Quick Start Guide
Thank you for purchasing the Full HD Warrior sports action camera. The
Warrior camera can be mounted with the Bike & Helmet Kit or the Board Kit for
the ultimate adventure HD recording experience.
Getting to know your Warrior camera
✔
Warrior camera is a Professional, High Quality Digital Video
Recorder that records in Full HD video by using a simple button
operation.
✔
It also has the latest Mega Pixel Sensor for you to take great digital
photographs.
✔
Your camera can capture color video & picture in low illumination (for
Warrior G1S only).
✔
Your camera has a MicroSD card slot(up to 32GB), which allows you
to take video in 1080p@30fps for about 6～12 Hours according to image
quality and bit rate.
✔
The embedded 3400mAh Lithium-ion Battery can last for 6 Hours,
standby for 12 months and be recharged quickly.
✔
The Waterproof Housing lets the camera perform up to 5 meters under
water.
✔
Warrior camera is light than 5.2 ounces or 145g.
Warrior G1SA
Advertisement
Table of Contents
Summary of Contents for XM Warrior G1SA
- Page 1 Quick Start Guide Warrior G1SA Thank you for purchasing the Full HD Warrior sports action camera. The Warrior camera can be mounted with the Bike & Helmet Kit or the Board Kit for the ultimate adventure HD recording experience. Getting to know your Warrior camera ✔...
- Page 2 1. Getting to Know Your Camera...
- Page 3 1. Turn the camera on Main Button 2. Take single photograph by short-press Photo/Video/Power 3. Take video by long-press Show the camera status Flashing green once: Take a photo Flashing green continuously: Recording video LED Indicator Always green: Camera turn on No light: Camera turn off Flashing blue continuously: WiFi turn on Flashing red continuously after power off: Remote control pending...
- Page 4 Power off: The Warrior camera can be automatically power off after 30 seconds if no recording video, you can also mandatory power off by pressing main button and WiFi button at the same time. ( you can setup Auto Power off time by Home7 App, MainMenu->Setting->General Setting) 2.3 Recording Video Long-press the main button to start / close recording video, default...
- Page 5 3. Connecting Your Camera 3.1 Connecting Your camera to iOS or Android App 1. Open the Warrior camera WiFi,long-press the WiFi button at back. 2. Mobile phone search and connect with WiFi hotspot(default name is xmjp_spt_xxxx) 3. Open Home7 App, then you can see the realtime video. Notes It requires iOS 7.4 and Android 4.0 version or above Home7 App...
- Page 6 4. Specification Model Warrior G1SA Sensor 2 Mega Pixel Sony Starlight CMOS sensor Lens 165°ultra wide angle field of view 1080p@30fps 720p@60fps Video 720p@30fps 1024*576@120fps Resolution: 2 Mega Pixel in JPEG format Photo Capture Modes: Single,Burst,Time lapse,Countdown Audio Built-in high quality microphone...
- Page 7 Battery has no enough power or Memory card is fully filled. Why the camera’s LED is red after power off? Because remote control function is pending, you need to close remote control function through short-pressing WiFi button. How to reset to factory default setting? Pressing reset button at back until hearing a voice.
- Page 8 FCC STATEMENT IMPORTANT INFORMATION FCC ID: 2AEP6XM-JPG1-2 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation.