Table of contents Limited Warranty registration form Service inquiry form Introduction & Safety Important Consideration Identify parts & Description Specification Dimension Drain Connection Installation summary Space Requirement Power Discharge Pump Pipeless Whirlpool motor 14-16 Base inner structure Massage Remote control ( functions) Massage Mechanism Chair back rest Holding Mech Trouble Shooting...
Limited Warranty Registration Form IMPORTANT To validate the limited warranty, The Limited Warranty Registration Form MUST be filled out completely and return to J&A USA within 30 days of original purchased date. This Limited Warranty is valid if J&A USA received registration form. Serial No.: Area Code: Phone :...
After Service Inquiry Form Please use inquiry form as all service request (Fill out all blanks and Fax or email us, our A/S Dept. will call you promptly) Distributor Name:____________________________________________ Date_________________________ Phone Number:____________________________________________ Contact Person:____________________________________________ Salon Name:____________________________________________ Address:_______________________________________________________________________________________ _______________________________________________________________________________________ Phone Number:____________________________________ Alternate Phone Number:___________________________ Contact Person:____________________________________ Best time to reach: ________________________________ Serial Number: ____________________________________ Brief Description of Problem:_____________________________________________________________________________...
Important Considerations For Installation Electrical Service 110V, 60Hz, 15Amp GFCI protected grounded circuit MUST be used to supply power each individual pedicure spa. And the main circuit breaker MUST be at 25Amp. Water Supply All plumbing connections must conform to local codes. Water supply to the spa should be provided with adequate water pressure and water temperature.
Space Requirement 56” 120Vac GFI Protected Hot and Cold Water 16” 68” Optional - Discharge pump Check Valve GFCI Shut Off Valves Top Rear View Hot and Cold Water Inlet : 1/2” Drain OutLet : 1 1/2” PVC Pipe Space Req, for Swivel to Side to Side 30 1/2”...
L E N O X Discharge Pump ( Optional): Up to 4ft @ +/- 39 sec. with 1/2” Connection to main drain DRAIN OUTLET MUST BE ½” FOR EFFICIENT DRAINAGE. ½” Brass Check Valve PLUMBER MUST BE UTILIZED TO INSTALL CHECK VALVE (SMALL Rubber Coupling) Air Check Valve...
Page 14
When using electrical equipment, Basic safety precautions must be followed to reduce the risk of fire, electrical shock, and injury to Persons. 1. Read and follow all instructions before using the equipment. 2. Keep electrical cord out of heavy traffic area. To avoid fire hazard NEVER place electrical cord under the rug, near heat Generating devices.
Page 15
How to USE Magnetic jet ! WARNING: DO NOT RUN DRY, BASIN MUST FILLED WITH WATER TO LEVEL INDICATOR. CAUTION: MAGNETIC JET COVER ASSEMBLY MUST ALIGN WITH DISCHARGE PORT POSITIONED AT 3/9 O’CLOCK. WHEN READY TO USE, MAKE SURE JET COVER IS POSITIONED AT 3 /9 OCLOCK FOR PROPER WHIRLPOOL ACTION IN THE BASIN.
Page 16
Dura-Jet III Safety Instructions When using electrical equipment, basic safety precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons, including the following: 1. Read and follow all instructions before using the equipment. 2.
LENOX MS REMOTE CONTROL INSTRUCTION POWER On / Off INCLINE BACKWARD Press down to move chair Press to hold to move To desirable angle. chair to desirable position FORWARD RECLINE Press to hold to move Press down to move chair chair to desirable position To desirable angle.
Massage Mechanism Back cover Open View Chair Main Frame Massage Mechanism Frame Mechanism Limited frame Bar Phillip Screws Kneading Belt Belt Pulley DC Motor (Kneading) Massage Arm extension Mechanism Track Guide Roller Tapping Belt Massage Mechanism Up and Down Gear Box Travel Signal Frame Fasteners Sensor...
Placing Backrest in Correct position Top View (Seat Frame) Color code Receptacle Connection location: Under Seat Cushion Red : Tilting (Up & Down) Black White : Slide ( forward and back) White Green: Seat Vibration Green Black : 2nd remote Pull latch upward to release...
Troubleshooting Guide If there is still a problem after trying the solutions given in the troubleshooting guide, stop using the product immediately so as to prevent accident or injury and unplug the product from the wall outlet. For technical service, please contact J&A technical support at 631-243-5300 with any issue that cannot be resolved using troubleshooting guide.
Page 22
Reset the main power switch located at the rear of the chair to OFF and back ON after about Massage stops in the middle of 5 second. the program 1- if the chair return to normal, No further action is required. 2- if the chair does not return to normal, stop using the chair and unplug it from the wall outlet.
USER’S FOR CUSTOMER RECOMMENDATION PLEASE READ THE MANUAL THROUGHLY BEFORE USE TO ENSURE CORRECT OPERATION. THOSE UNDER A DOCTORS CARE OR WHO ARE EXPERIENCING ONE OR MORE OF THE FOLLOWING CONDITIONS SHOULD CONSULT THEIR DOCTOR BEFORE USE ** You are receiving medical treatment or are feeling ill. ** Your body shows any acute symptoms.
In accordance with applicable Local or State regulations, J&A USA Inc., The manufacturer of the pedicure whirlpool spa certifies that the following models are equipped with factory installed Dual Check Valve back flow preventer: ** Lenox Series ** Cleo Series ** Episode Series...
Glass bowl Care and Cleaning CARE AND CLEANING Clean the surface of your JSG Oceana glass product with mild soap and warm water. Wipe the entire surface completely dry with a clean, soft cloth. MANUFACTURER’S RECOMMENDED DRAIN INSTALLATION Drain installation requirements will vary by supplier basin and unit. Manufacturer’s drain installation instructions suggest to apply plumber’s putty under rim of drain and hand-tighten drain only.
Limited Warranty Pedicure Spa IMPORTANT To validate the limited warranty, The Limited Warranty Registration Form MUST be filled out completely and return to J&A USA within 30 days of original purchased date. This Limited Warranty is valid if J&A USA received registration form. J&A USA Inc.
Need help?
Do you have a question about the MS and is the answer not in the manual?
Questions and answers