Table of Contents
Advertisement
Options
To Start
Dishwasher
After loading set the dial to the desired cycle.
Temp
Boost
Sensor
Press button for desired options.
If for any reason the incoming water
temperature
is below 120°F, press the On
NOTE: Run the water from the hot water tap to
button to assure the water is heated to proper
clear the line of cold water before
temperature
for best cleaning and drying
starting.
results. The dial will pause at the _ to extend
the main wash and the Heating Delay light will
Press the door until it latches. The cycle will
turn on.
begin with a drain prior to fill and the On
indicator will light.
Press the Offbutton
to cancel the Temp Boost
Sensor.
Indicator
Lights
Heated
Rinse
and Dry Options
The On light indicates that the dishwasher is
RINSE TEMP
operating.
Press the Sani button to turn the beating
The Heating Delay light indicates that the main
element on during all rinses. The Sani option
wash is being extended to heat the water to
helps maintain water temperature
and improve
proper temperature.
drying results.
Press the Normal button if Sani is not desired.
At the end of the dry phase the Clean light will
The beating element will be turned offin alI
remain lit until the dial has been advanced to
rinses,
the _.
FAN DRY
Adding
a Forgotten
item
Press the Heat button to turn the heating
For best cleaning, the forgotten item should be
element on during the fan dry period. This
added early in the cycle.
option improves drying results.
1. Unlatch the door and wait until the sound of
Press the Mr button to turn the heating element
off during the fan dry period. Towel drying may
circulating water stops.
be necessary.
2. Open the door and add the item.
NOTE: Temp Boost Sensor, Rinse Tcmp and
3. Pause before latching the door. The cycle will
Fan Dry options can be used separately
or together,
continue at the point it was interrupted.
PAGE 9
Advertisement
Table of Contents
