Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Thermaltronics TMT-ST10
- Page 1 USER MANUAL TMT-ST10 SOLDERING TIP TESTER www.thermaltronics.com...
-
Page 3: Table Of Contents
If the product should become defective within the warranty period, Thermaltronics will repair or replace it free of charge at its sole option. Warranty period is from the date of purchase by the original owner. If the date of purchase cannot be substantiated the date of manufacture will be used as the start of the warranty period. -
Page 4: Tmt-St10 Specifications
Thermaltronics prior to shipment, and with proper maintenance will give you years of reliable performance. SYSTEM FEATURES The TMT-ST10 is a multifunction soldering tip tester, it has the following measurement functions: • Tip temperature (°C/°F switchable) •... -
Page 5: System Features
(2) LCD Display - Displays test parameters and info messages. (see: Control Panel - LCD Display) (3) Mini USB Port - Use the mini USB cable (ST-CABLE-1) to connect the TMT-ST10 to a computer in order to read stored test data. -
Page 6: Control Panel
● Long Press - pressing and holding the "SAVE" button for more than 3 seconds will save the data from (b) Tester Memory to data storage. Afterwards the data can be downloaded to a computer through the mini USB port. TMT-ST10 Solder Tip Tester... -
Page 7: Unpacking/Assembly/Operation
Important: Keep all shipping materials until satisfactory operation has been verified. Assembly 1. Remove TMT-ST10 solder tip tester from its box and place on a suitable work bench. 2. Install a 9V battery into the back of the test meter. - Page 8 USER MANUAL UNPACKING/ASSEMBLY/OPERATION Operation - Test Temperature 1. Turn on the TMT-ST10 tip tester. 2. The tip tester will default to Tip Temperature Test mode. 3. Press the "RESET" button to switch between Celsius (C) and Fahrenheit (F) display. 4. To test temperature, touch the solder tip onto the (6) Thermal Sensor. Allow a few seconds for the reading to stabilize.
-
Page 9: Software Functionality
• Clear tip tester memory after downloading and saving - if selected TMT-ST10 memory will be cleared after test data has been downloaded to the computer. • Sync tip tester date and time after download - if selected TMT-ST10 date and time will be synched to the computer date and time. -
Page 10: Calibration
Otherwise test accuracy will be affected. • Please make sure the thermocouple sensor is at room temperature. Whenever the TMT-ST10 is turned on (LCD Display shows “ Welcome”), the TMT-ST10 will self- calibrate it’s reference temperature point. -
Page 11: Calibration
Note: Please make a note of this voltage value as it will be used later to calibrate the tester. 2. Use the mini USB cable (ST-CABLE-1) to connect the TMT-ST10 to a computer through the Mini USB Port. 3. Run program commix.exe series port management program found on the installation cd 4. -
Page 12: Ordering Guide
ORDERING GUIDE TMT-ST10 THERMALTRONICS SOLDER TIP TESTER PART NUMBER DESCRIPTION TMT-ST10 Solder Tip Tester ST-CABLE-1 Mini USB Cable ST-SNSR-1 Temperature Sensors (10 Pack) ST-GWIRE-1 Ground Wire (EU Plug) ST-GWIRE-2 Ground Wire (US Plug) ST-GWIRE-3 Ground Wire (CN Plug) www.thermaltronics.com support email: support@thermaltronics.com... - Page 13 Support Email: support@thermaltronics.com www.thermaltronics.com...
Need help?
Do you have a question about the TMT-ST10 and is the answer not in the manual?
Questions and answers