Advertisement
Advertisement
Table of Contents
Summary of Contents for ERNITEC BED-108/2
- Page 1 Installation Instructions BED-108/2 Simplex RS485 Distribution Amplifier...
-
Page 2: Box Installation
1200 m POWER Installation Box Installation The BED-108/2 should be mounted at a suitable location where mains is available. The box should be mounted on a plane surface to avoid twisting of the box, resulting in possible leakage. ERNITEC DATA +10V 0498-00053 V.0.1... -
Page 3: Mains Installation
BED-108/2, or the connected equipment. All cables to and from the BED-108/2 are fed through the cable glands. Choose an appropriate size gland for the actual cable and tighten the glands when all cables are connected. - Page 4 These standards covers equipment installed in an industrial environment. The BED-108/2 fulfil the following safety standard: IEC 60950 BED-108/2 Layout The BED-108/2 has been designed for easy installation and set-up. The below figure shows the layout of the Simplex RS485 Distribution Unit. ERNITEC DATA +10V 0498-00053 V.0.1...
-
Page 5: Mains Connection
Make sure that each terminal is connected to the corresponding terminal of the mains outlet (i.e. Phase to Phase, Neutral to Neutral and Earth to Earth). Otherwise malfunction or even damage to the BED-108/2 will occur. For specification of mains, refer to Specifications, at the end of these instructions. -
Page 6: Specifications
Installation Instructions BED-108/2 Specifications Specifications Description Parameter Min. Max. Unit Note Inputs ERNA, RS422 or simplex RS485 Impedance Current consumption Outputs ERNA, RS-422 or simplex RS-485 (8x) Load impedance Potential free Power failure Relay contacts using 0.6 mm solid copper twisted... - Page 7 TELEPHONE: (040) 6756 25 0, TELEFAX: (040) 67 56 25 25 E-MAIL: ernitec@aol.com FRENCH OFFICE: ERNITEC FRANCE, N° 29 PARC CLUB DU MILLENAIRE, 1025 RUE HENRI BECQUEREL, 34036 MONTPELLIER CEDEX 1, FRANCE TELEPHONE: (4) 67 15 10 15, TELEFAX: (4) 67 64 01 81 E-MAIL: ernitec@ernitec.fr...
Need help?
Do you have a question about the BED-108/2 and is the answer not in the manual?
Questions and answers