Summary of Contents for UDOIT RFT-868-USB
-
Page 1: Wireless Network
RFT-868-USB WIRELESS NETWORK USER MANUAL 868.3 MHz RFT-868-USB USB RFTide Network Interface Release A - 01/09/2015 Copyright 2015 Udoit Srl - All rights are reserved www.udoit.eu... - Page 2 Home and building automation. Industrial monitoring and control. Remote wireless control. Revision History Date Version Revision 15/09/2015 Initial Release Refer to SEMTECH SX1211 Transceiver datasheet http://www.semtech.com/images/datasheet/sx1211.pdf Release A - 01/09/2015 Copyright 2015 Udoit Srl - All rights are reserved www.udoit.eu...
- Page 3 Failure to observe recommendations included in this manual may be dangerous or cause a violation of the law. The manufacturer Udoit Srl will not be held responsible for any loss or damage resulting from not following the instruction of operating manual.
- Page 4 RFT-868-USB DESCRIPTION ............................5 FIRST CONFIGURATION ........................6 RFTIDE COMMUNICATION PROTOCOL..................9 Release A - 01/09/2015 Copyright 2015 Udoit Srl - All rights are reserved www.udoit.eu...
- Page 5 (see RFT-868- MAG, RFT-868-PIR. RFT-868-4CH and RFT-868-RELAY-S manuals) . For its controlling access and to have full management of the network a Control Unit must be connected to the RFT-868-USB device in order to setup and configure the RFTide network.
-
Page 6: First Configuration
In order to control data exchange it is possible to send commands through a serial port using an esternal microcontroller or a PC. Referring to Figure 2, follow these configuration steps: 1. Connect the RFT-868-USB device to a usb 2.0 port (e.g. Personal Computer, Raspberry Pi…). - Page 7 RFT-868-USB Figure 3 Software apllication for the RFT-868-USB After connecting the RFT-868-USB select the proper serial Port and push “Set”(see Figure 3). Pressing “Local Status” will show the address number, the Network ID, the Profile (None) and the firmware version.
-
Page 8: Communication Protocol
(see PING Message RFTIDE section on COMMUNICATION PROTOCOL Doing chapter). the same activity for all the RFTide devices permit to establish the desired RFTide network. Release A - 01/09/2015 Copyright 2015 Udoit Srl - All rights are reserved www.udoit.eu... - Page 9 Referring to Figure 3, on the “Ping” section of the “Network Install” part, it can be tested the radio communication between the RFT-868-USB device and the other node by sending a “ping” packet. Just filling the “Ping Address” field and click the ”Ping” button, if everything goes well, an answer message will be received.
- Page 10 Figure 5 Send Packet Sequences Depending on the text, this kind of message is multi-purpose: • STATUS_REQUEST (for RFT-868-PIR, RFT-868-MAG, RFT-868-RELAY-S). • ON-OFF Command (for RFT-868-RELAY-S). Release A - 01/09/2015 Copyright 2015 Udoit Srl - All rights are reserved www.udoit.eu...
Need help?
Do you have a question about the RFT-868-USB and is the answer not in the manual?
Questions and answers