Table of Contents
Advertisement
Symptom
Possible cause/Remedy
<
No picture
<
<
<
Poor picture
<
<
<
<
Poor colour
<
<
No sound
<
<
Sound and picture
interruptions using
<
HDMI to HDMI
connection
< Alternatively, connect an extra audio cable (either an analogue or a digital audio
< Limit the HDMI cable length to max 5 m.
< Verify if the connected equipment is properly selected in the Installation menu,
< Verify whether you properly connected the audio cable to the DIGITAL AUDIO
No sound when
using DVI to HDMI
< Verify whether you selected the connected equipment in the Installation menu,
connection
<
No digital channels
<
No subtitles
(UK ONLY)
Troubleshooting
Verify if the supplied cables are connected properly. (The aerial cable to the
TV, the other aerial to your recorder, the power cables, ..)
Verify if you selected the correct source.
Verify if the child lock has been switched off.
Verify in the Manual installation menu if you have selected the correct TV
system.
Verify if your TV or house aerial isn't located too close to loudspeakers,
non-earthed audio equipment or neon lights, etc.
Mountains or high buildings can cause double pictures or ghost images.
Sometimes you can improve the picture quality by changing the direction of
the aerial.
Is the picture or teletext unrecognisable or do you experience bad teletext
reception ? Verify if you have entered the correct frequency, or fine tune the
frequency for that specific channel or adjust the antenna direction if the problem
isn't solved by finetuning. See Installation,Analogue: manual installation, p. 29.
Select Factory settings in the Installation menu.
Verify the connections between the optional equipment and the TV.
Verify if the volume isn't at minimum.
Verify if the sound hasn't been muted with the
Verify the connections between the optional equipment and the TV.
If it occurs occasionally, perhaps there is something wrong with the broadcasted
programme.
If it occurs persistently, see the manual of your connected equipment to verify the
necessary adjustments.
cable) from your connected peripheral to your TV.
Verify whether you selected the connected equipment in the Installation menu,
Select your connections and also select the respective audio input in the same
Connections menu.
Note: An analogue audio cable must be linked to HDMI 2.
Connections, according to the connection you have made HDMI 1 or 2.
IN connector of the TV.
Select your connections and if you linked it to HDMI 1 or 2 according to where
you made the connection.
Also verify if you selected digital audio in in the same Connections menu.
Contact your dealer about Digital Video Broadcasting Terrestrial signal availability
in your country.
Under certain circumstances Digital text or interactive services may have priority
over subtitles.This can result in the subtitles not automatically reappearing when
leaving Digital text or interactive services on a channel which is broadcasting
subtitles. In these cases subtitles can be initialised, either by toggling the OPTION
or the MENU key on the remote control or by changing channel.
¬
key.
EN
55
Advertisement
Table of Contents
