Subscribe to Our Youtube Channel
Summary of Contents for Visionary Solutions PSA200
- Page 1 PSA200 User’s Manual ©2006 Visionary Solutions, Inc. All rights reserved.
-
Page 2: About This Guide
Customer Obligations The original, dated, bill of sale should be retained as proof of purchase and must be presented to the Visionary Solutions, Inc. or a Visionary Solutions, Inc. Authorized Service Center when this equipment is to be serviced under the provisions of this warranty. - Page 3 The PSA200 User’s Manual 1.1 The PSA200 The PSA200 power supply is an International AC input (100-240VAC, 200 Watt) unit provided for the MPP1700. It complies with the compact PCI standard, and is a 3U high 8HP wide. The power supplies can be inserted into slots 18 and 20 of the MPP1700.
-
Page 4: Power Supply Installation
PSA200 User’s Manual Two LEDs are provided on the PSA200. 1. The Input OK LED will illuminate green when the supply is properly installed, power is applied, and the system is operational. 2. The Fault LED will illuminate red if a fault condition is detected. - Page 5 3. Press the red tab in the bottom injector/ejector handle to unlock the module. 4. Pull down on the handle and pull the module out of its slot away from the chassis. 1.3 PSA200 Safety and Compliance Caution: This component level power supply is intended exclusively for installation within other equipment by an industrial assembly operation or by professional installers.
- Page 6 Protective Earthing: The PSA200 must be properly grounded to mains protective earthing termination at end use. Fusing: In case of failure, the PSA200 must be returned to VSI. There are no serviceable parts in the power supply. Overall Size: 6.40 in. (162.5 mm) x 5.07 in. (128.7 mm) x 1.60 in. (40.6 mm)
- Page 7 Visionary Solutions, Inc. 4193 Carpinteria Avenue Suite 11 Carpinteria, CA 93013 T: 805-566-5811 F: 805-566-5813 www.vsicam.com September 2006...
Need help?
Do you have a question about the PSA200 and is the answer not in the manual?
Questions and answers