Summary of Contents for Kangjie JKA
- Page 1 JKA STAGER CONTROLLER SERVICE MANUAL Shahe Industrial Zone,Changping District,Beijing, China, 102206 Tel: (+86) 010 6973 0336 Fax: (+86) 010 8070 6936 www.kangjiezc.com Email:kj@kangjiezc.com...
- Page 2 1. General Introduction 1.1 JKA stager controller is the product developed on the basis of advanced technology. It is widely being applied in various water treatment fields as Filtration System, Water Conditioning, Softening System and Desalination Systems, etc. The main distinguished features of JKA Controller are: Power: 150~250V/AC, 50/60Hz, 4W;...
- Page 3 stager operation: ESC : functional exit; : select /modify parameter; : move cursor; ENTER: confirmation/input. Note: keeping any key 5 seconds can get into setting state on main display. The setting point is up by 1 when the upward key is pressed each time, and will be down by 1 when the downward key is pressed each time.
- Page 4 2.1 Power Supply Connection. Properly link JKA Stager Controller to power supply before starting parameter setting. The screen displays as below: 2006-03-21 14:18:58 NEXT Remote 2.2 Setting procedure 2.2.1 Password input: constantly press any key on main display for 5 seconds, the screen...
- Page 5 program, display as follows: Mode Business Mode setting: move the cursor to Mode and press ENTER to access to Modes choice, display as below Mode: Volume Remote Interval Week Timing Note: Which regeneration mode is identified in the light of actual technique. Volume mode selection requires flow sensor matched that can generates rectangular pulse.
-
Page 6: Interval Time
timing as system regeneration mode, moving cursor on Week timing and press ENTER to access, display as below Week Plan SU MO TU WE TH FR SA Pushing keys sets date and time requested to regenerate, then press ENTER to get into, display as below Week Timing 01: 00: 00 Note: Interval mode setting. - Page 7 ENTER (3 stager as example), display as below Program: 1/3 stages Time: 0000 seconds Push and press ENTER to access step width setting of first stage. Adjust this step width based on systematic requirement (from 1 second to 9999seconds). Up completion, press ENTER to confirm this setting.
- Page 8 15 terminal COM. 14 terminal is no connection. Instruction: terminal 25 and 26 are two input points of external feedback signal. Regeneration of JKA Stager Controller is restrained immediately when any of both forms short circuit with COM linking. As far as releasing external feedback signal, regeneration can be available.
- Page 9 Know present date, time, week and remote control mode when Remote mode is selected. JKA stager controller activates regeneration when residual flow rate/time value reaches setting or is received remote signal. Under the regeneration states, screen displays various stages’ information accorded with below...
- Page 10 3.2. Manpower initiation or stop Move cursor by pressing to Manu and then push to initiate 强制 regeneration. Display as below 2006-03-21 14:18:58 Next Remote When regeneration program initiated, residual time of first stage decreases by 1. Till zero, program goes into second stage. Press ESC constant for 5 seconds to stop regeneration, display as below.
- Page 11 Press ENTER to skip one stage. Above description is general instruction of JKA stager controller, if any question in your use please contact to us with any hesitate. Appendix K value reference (national PN10 and metric PVC pipe standard) Metric PVC Pipe...
Need help?
Do you have a question about the JKA and is the answer not in the manual?
Questions and answers