Hardware Connection; Led Status Indication - SmartRG SR300NE User Manual

2.2 HARDWARE CONNECTION

Introduction：
1、 Use a telephone cord to connect the LINE port of the splitter with the RJ-11 port (the phone jack) on
the wall.
2、 Use another telephone cord to connect the ADSL port of the splitter with the LINE port of the ADSL
Modem.
3、 Use another telephone cord to connect the telephone set with the PHONE port of the splitter.
4、 Connect Ethernet port of the ADSL MODEM with 10/100BASE-T port of the computer using the
network cable that comes with the modem.
5、 Plug in the power cord, and turn on the power.
If you do not want Internet services and telephone voice services simultaneously, please just connect the
LINE port of the ADSL Modem with the RJ-11 port (the phone jack) on the wall using a telephone cord. In this
case, the splitter is not necessary.

2.3 LED STATUS INDICATION

Table 2.3
Status POWER
(red)
Steady Power on
light
Flashing /
Fast /
flashing
Off Power off
LINE Connected with telephone line
Connect with the LINE port of the
ADSL ADSL Modem using telephone
line provided.
PHONE Connect with telephone
DSL (green)
The modem is in good
connection
In handshaking status
/
Connection not set up
INTERNET WIRELESS(green)
(green)
/ Wireless is
connected
/ /
Transmitting or Transforming data
receiving data
Not connected Wireless is
with PC disabled
properly
Page 5
DSL Gateway/Router — User Manual
WPS(green,optional)
There exists WIFI
client connecting to
the Ddevice
WIFI client is trying
to connect
/
There no WIFI client
connecting to the
Ddevice
Total 21 Pages