Advertisement
・ Tap the Refresh button/icon
・ Select the corresponding ID of the receiver/model
・ Tap the Bind button/icon
・ The receiver/model should now be bound to the ST24. Or, if the receiver/model was not bound
successfully repeat the steps outlined above to complete the binding process.
3. Define the channels
・Return to the main RC Mode screen (tap the 'Back' or 'Home' icons located near the bottom of the
screen as needed)
・ Tap the Channel Settings button/icon
NOTE: If the ST24 did not recognize the receiver/model and automatically identify the number
and type of channels a corresponding menu will pop-up and you will be prompted to set the
number of analog and switch channels accordingly
・Select the output channel/function (Thr, A01, etc) you'd like to view
・If you prefer to change the default input device/hardware (J1, K2, S3, etc.) set to control the selected
output channel/function, tap the corresponding input device/hardware button then tap Deactivate and
proceed to the following steps
・ Select the new input device/hardware to control the selected output channel/function by tapping
the desired input device/hardware button, then tap Edit to adjust the corresponding details (reverse,
travel adjustment/rate, speed,etc.)
NOTE: You can set Priority, Edit, Deactivate or view the Properties of each channel.
You can also define which switch controls the Flight Mode.
・ There are multiple levels of mixing priorities. The highest level input device/hardware will be pro-
cessed first.
・There are multiple types of basic expo and control curves that can be selected for each output chan-
nel/function. If you want to adjust any curve you can use the buttons above and below the graph or
you can touch the curve on the graph directly.
・ Reverse, Dual Rate (D/R) and even output Speed can be changed as needed/preferred.
・ After making any changes you MUST tap the Save button to save them.
・ Return to the main RC Mode screen (tap the 'Back' or 'Home' icons located near the bottom of the
screen as needed)
Using Your ST24
In the First-Person View (FPV) Mode
For FPV/camera-equipped models
1. Power on the ST24 and enter RC mode
・ Slide the Power Switch to the left to power on the ST24
NOTE: The switch does not extend beyond the surface of the transmitter to minimize the risk of acci-
dentally powering the transmitter off during use
Power Switch
・ Tap the FPV button/icon
・ Tap the Model Select button/icon
・ Select the type of model (Multi-copter, Airplane, etc.) you'd like to create or load
Advertisement
