Shenzhen Baoan Hantong Electronics COLUMBIA FRS-S14 Owner's Manual

Two-way

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

OWNER' S MANUAL

PLEASE READ THIS MANUAL CAREFULLY BEFORE USE.

TWO-WAY COMMUNICATOR

COLUMBIA

LOCK

LAMP

CALL

SCAN

PRIV

BEEP

MODEL: FRS-S14

Table of Contents

Need help?

Do you have a question about the COLUMBIA FRS-S14 and is the answer not in the manual?

Questions and answers

Summary of Contents for Shenzhen Baoan Hantong Electronics COLUMBIA FRS-S14

Page 1 TWO-WAY COMMUNICATOR COLUMBIA SCAN PRIV BEEP LOCK LAMP CALL OWNER’ S MANUAL MODEL: FRS-S14 PLEASE READ THIS MANUAL CAREFULLY BEFORE USE.
Page 2: Carton Contents
COLUMBIA CARTON CONTENTS COLUMBIA Two-Way Communicator User-Removable Belt Clip Owner’s Manual Warranty Card * Attached to the units at the time of packaging WARNING! DO NOT CHARGE UNIT USING AC/DC ADAPTER WITH REGULAR AAA ALKALINE BATTERIES INSTALLED. ONLY USE THE AC/DC ADAPTER WITH AAA NI-MH RECHARGEABLE BATTERIES.
Page 3: Fcc Notice
FCC NOTICE Warning: Adjustment to this unit or replacement of any transmitter component (crystal, semiconductor, etc.) to this unit that could result in a violation of the rules. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Page 4: Feature List
FEATURE LIST A . GENERAL a.14 CHANNEL b.38 CTCSS CODES PER CHANNEL c. BATTERY (“AAA” 1.5V X 4 ) d. LCD DISPLAY (RF CH, CTCSS CODE CH, RX/TX STATUS, LOCK INDICATOR, LOW BATT. INDICATOR) e. FIXED FLEX ABLE RUBBER ANTENNA f.
Page 5: Frequency Range
1. FREQUENCY RANGE CHANNEL FREQUENCY (MHz) CHANNEL FREQUENCY(MHz) 462.5625 467.5625 462.5875 467.5875 462.6125 467.6125 462.6375 467.6375 462.6625 467.6625 462.6875 467.6875 462.7125 467.7125 2. CTCSS CODE FREQUENCY CHART CODE FREQUENCY(Hz) CODE FREQUENCY(Hz) 67.0 131.8 71.9 136.5 74.4 141.3 77.0 146.2 79.7 151.4 82.5 156.7...
Page 6: Controls And Displays
Controls and displays Controls and displays 1. Belt clip 2. Microphone jack 3. Speaker jack 4. Antenna 5. Mode 6. Lock 7. Lamp 8. Call 9. Down 10. Up 11. On/Off / Volume knob 12. Microphone 13. Monitor button 14. PTT (Push To Talk ) button 15.
Page 7 Setting Up Your FRS Radio Battery Installation Batteries are not included with your FRS radio, To use the radio, you must install 4 AAA size alkaline batteries. Always use high quality batteries in the unit, to prevent damage from leaking or corrosion. Caution: incorrect positioning or the batteries can damage both the batteries and the unlit.
Page 8: Operation
Operation LCD Panel Display CTCSS Code Channel Transmit Symbol Number SCAN Receive Symbol PRIV BEEP Battery Level Low Battery Indicator Kaylock Symbol Turning On Your FRS Turn the ON/OFF Volume knob clockwise on the top of the unit. An audible tore will generate and The RF channel indicate on the LCD. Communication You can communicate two ways your new FRS radio.
Page 9 Operation Receiving communications When your FRS unit is turned on and is not being used to transmit voice communication or pages, it is always in the listening mode. You can not receive any transmissions when the TALK or CALL buttons are pressed, even if you are not saying anything.
Page 10 Operation Changing Channels This set has 14 available channels, To change channels: 1. Press the Mode key the channel number digit will flashes on the LCD panel. 2. While the channel number is flashing. * Press the UP ( ) key to increase the channel number. * Press the DOWN (¨...
Page 11 Operation Note: CTCSS codes are mainly used for blocking unwanted calls over a crowded channel. Other users in the same channel can still hear you, but you cannot hear them unless they have the same CTCSS code that you have set. Range Your FRS unit has a range of up to 2 mites This range can be decreased by certain atmospheric and environmental...
Page 12: Special Features
Special Features Automate Squelch You FRS is equipped with automatic squelching circuitry, which will automatically filter out weak transmissions and unwanted noise. These signals may be picked up as background static, and are usually cause by terrain conditions or if you have reached the limit of your range. Monitor button You can use the Monitor feature to listen in for weak signals in the current channel.
Page 13 Special Features Channel scan Your FRS unit can scan for 14 channels. To scan the unit. * Press Mode and UP buttons at the same time. * Channel indicator will change continue. * Once received any signal scan will stop and listen for 4 second. * Press talk button and talk on that channel (scan will automatically stop ) or press up key to scan continue.
Page 14: Specifications
Specifications Specifications 1. Channels available : 14 Channels (see channel table) 2. Output Power (Tx) : 0.5W (FCC Maximum) 3. Battery life : 20 Hours (typical) FRS Channel Table FREQ (MHz) CTCSS Channels 462.5625 462.5875 462.8125 462.6375 462.6625 462.6875 462.7175 467.5625 467.5875 467.6125...